sensitivity for sensors.
it might be the change of effective index with respect to the changes of the refractive index of cladding
or the change of measured power as refractive index of cladding changes
Thank you for your prompt respond.
does changing the material properties affect the performance of the sensor?
01 January 1970 9,972 0 View
I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...
26 February 2021 1,511 3 View
Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...
21 February 2021 2,333 4 View
My team is designing a dual channel microfluidic chip that runs air and water. I think we've decided on the NE1000 syringe pump for it's versatility and feedback control. We will be ordering the...
18 February 2021 9,928 2 View
Hello researchers! While studying the literature on refractive index sensors, most of the articles simulate their devices with a refractive index ranging from 1 to 1.1, with small steps in...
17 February 2021 1,578 4 View
Our team is designing a smart water C&C dashboard for a smart city initiative. As we look into the current smart water system landscape, we couldn't reconcile to a definitive solution that...
16 February 2021 1,094 3 View
I am doing a three point bend test with concrete specimen of dimension 280mm*90mm*90mm. I am putting 2 sensors near the notch with 3cms away from both the sides. the experiment ran for 20 mins but...
13 February 2021 2,990 1 View
Hello great researchers, I am working on a wireless pressure monitoring project where sensing part is actually an LC resonance sensor and I am using a planar coil as a reader to get wireless...
11 February 2021 4,148 5 View
I am working on a landslide model...i need an optical sensor to determine the amount of pore pressure and other values..i am thinking of using a microbend sensor. Can anyone please provide me with...
11 February 2021 5,911 2 View
When I am trying to implement a pressure sensor through instrumentation amplifier and then giving it's output to Arduino, I am getting garbage value due to noise, so how to eliminate it.
05 February 2021 8,598 11 View
Hi I have to compare the uniaxial sensor(wearable) data with Triaxial sensor data(IMU). The uniaxial sensor output has a single column of activity counts whereas Triaxial sensor(IMU) has three...
05 February 2021 3,999 1 View