How to size battery banks?

I am designing a small grid connected solar PV power-plant. As the battery's capacity is specified in Ah and demand in kWh. What is the best way to size the battery bank? I have battery price in...

28 February 2021 1,638 3 View

Do you think there is cognitive oversaturation in the current pandemic? What impact can this have? And other manifestations?

Dear colleagues, Do you think there is cognitive oversaturation in the current pandemic? What impact can this have? And other manifestations? The question is mainly aimed at adolescents (pupils,...

23 February 2021 7,796 4 View

What is the standard protocol in doing replicates for C. elegans lifespan assay on solid media (thru worm picking)?

I would like to know what is the standard protocol in the number of worms per plate and number of plates per concentration of extract X in a lifespan assay done in solid media and not automated...

23 February 2021 9,933 1 View

What is the possible cause of MSCs low growing?

Hello Everyone, We are inexperienced in culture of MSCs trying to grow a sample from BM of a mare. It is the second time that after preparation of new medium (DMEM-F12 with high glucose - 10% Hy...

07 February 2021 9,989 7 View

What is better to buy a real-time pcr machine or an endpoint?

Hello everyone, we are acquiring a new molecular biology laboratory with the fundamental objective of identifying species of microalgae and cyanobacteria. Perhaps you could help us decide if it is...

24 January 2021 8,320 4 View

How to improve the yield for the reaction below?

I am trying to increase the yield for the reaction below. I did the column and I saw that the major side-product is the symmetric dimer formed by 4-bromobenzyl bromide. I imagine that NaH is...

20 January 2021 7,874 4 View

Is it possible to calculate the energy stored (kWh) in a EV battery by knowing the cathode discharge potential and specific capacity properties?

For example, if I have the following data for a LiNi0,8Co0,15Al0,05O2 compound used in the cathode: - Specific capacity = 200 mAh/g - Average voltage = 3,7 V I have no information about the...

16 January 2021 3,038 2 View

PCR used to work, now it doesn't, why?

I recently did a PCR with certain primers, and the reaction went well for two gels, but when I repeated the exact same reaction a third time it suddenly didnt work, then I did it a 4th time and it...

12 December 2020 364 5 View

Can you suggest a sub-problem and possible objectives regarding to this thesis/research study?

03 November 2020 8,155 3 View

DNA disappears from gel, whats going on?

Recently I've been doing some PCRs and the primes used to work a month ago, but now that we want to repeat the experiment, they are not working anymore. I have noticed something in my gels, and it...

28 October 2020 4,427 4 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Can we distinguish the type of free fluid inside the pelvic and abdominal cavities whether blood or serous fluid using the ultrasound?

during ultrasound examination of acute abdomen, sometimes we see free fluid , can we know the type of fluid ,whether blood or not , using ultrasound only? if yes , what are the sonographic...

01 March 2021 7,476 4 View

How much pressure we can reduce at the outlet to avoid Reverse Flow?

I am simulating Heat Exchanger. I have tried and tested all the methods to resolve this issue from the internet like refining mesh, improving skewness and orthogonal quality ,extending outlet to...

01 March 2021 6,985 3 View

How to show arrows over the streamlines in CFD-post?

I follow this to make streamlines like the photos attached below: (software- CFD post-processing) First I plot the 2D streamline over a surface "streamline 1". them I plot a vector by the...

01 March 2021 8,668 3 View

How to increase mesh quality of a cfd model in ansys fluent?

How can one improve mesh skewness, orthogonality, aspect ratio?

28 February 2021 7,730 3 View

Is there a deep reason for using the squared modulus of the wave function as the probability density of the existence of the particle?

I think we were all surprised at the first time we got to know quantum mechanics that the squared modulus of the wave function is the probability density of the existence of the particle? The role...

28 February 2021 6,282 9 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Is the a way to contol flow (Flow velocity) without impacting pressure value?

I have a pipe with 10 mm in Diameter and 2 bar pressure, the fluid velocity is 200 m/s, the fluid is air. is there a way to reduce velocity without affecting the pressure value?

25 February 2021 7,187 3 View