What is the advantage when we used as a polypyrrole and polyaniline and additionally rGO in a (PPy-Co-PAni)-rGO composites?

More Dr Prasanta Pattanayak's questions See All

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How are Large Models Exploring and Outputting Knowledge Understanding in Specific Content Areas, and What Does Academic Research Say About It?

Hello everyone！ I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...

05 August 2024 5,729 2 View

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity?

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...

03 August 2024 5,358 0 View

How do i get an account to upload my published papers?

need to open an account to upload my published papers

01 August 2024 9,255 1 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 589 4 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,233 4 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

Are you looking for research collaboration ?

we have few papers ready for submission, and we need one co-author for each article who can pay article fee. Interested authors may text here or contact me on my following email id [email protected]

29 July 2024 6,626 0 View

How to prepare polyaniline emeraldine salt ( PANI -ES) sample for Transmission electron microscope (TEM) analysis?

I need to do TEM analysis for my Polyaniline emeraldine salt form. May I know which solvent is appropriate for preparing TEM sample?

25 June 2024 9,086 3 View

Could you give me some advice on choosing a solvent for the PANI for gas sensing?

I ve got a PANI (organic solvent soluble polyaniline) and PANI (water soluble polyaniline). I try to use DMF and DMSO but i have noticed that for PANI(liquid) i cannot choosing best solvent and...

04 May 2024 4,274 4 View

Which interface layer can be evaporated at 100-200°C in forming a two-layered structure through multilayer formation?

What type of interface layer is appropriate for evaporation within the temperature range of 100-200°C when creating a two-layered structure using multilayer formation? Specifically, discuss the...

29 April 2024 5,640 2 View

Which is best solvent for polyaniline emeraldine solvent (PANI-ES) for spin coating on ITO substrate?

I have synthesized Polyaniline via chemical oxidative polymerization. I need to prepare a thin film of the same by using spin coating. But I am not sure which solvent to proceed with. Any imsights...

11 January 2024 4,042 11 View

Why is the following CV graph plotted?

We wanted to electrodeposit polyaniline by CV analysis. However, I got an OVERLOAD at the beginning and the gold dropped off a bit. Later, I ran the CV again and got the following blue graph....

17 December 2023 6,722 1 View

How can I deposit polyaniline on a gold film using CV analysis?

We are currently using a Pt counter electrode and gold-deposited PET as the working electrode in an electrolyte of 0.1 M aniline and 0.1 M HCl. However, when I performed CV analysis, I could see...

28 November 2023 5,401 2 View

How to get crystal structure information of Polymers using Xpert highscore ?

how can I match the XRD data of Polyaniline for getting structural information using Xpert Highscore ? While attempting for the same I am getting "no candidate found" as output.

25 November 2023 6,367 5 View

I want a conducting polymer substrate. How to make a selfstanding thick film of polyaniline?

i tried to make composites of pva and polyaniline to make selfstanding polyaniline films. But when it solidifies the resistance increases to MegaOhm range. How can i get a self-standing...

24 October 2023 1,073 1 View

Is that possible to make interpenetrating composite hydrogel with the polymer itself without the monomer ?

In my case, I am trying to prepare an interpenetrating composite hydrogel composed of PANI and another polymer, what I have seen in the literature review they used the monomer (aniline) can I do...

13 September 2023 6,013 3 View

Counter electrode reactions in electrodeposition of Polypyrrole?

I'm working on the electrodeposition of Polypyrrole on stainless steel by chronoamperometry at a positive potential of 1.17V in a LiClO4/CH3CN medium. My question concerns the cathodic reactions...

05 August 2023 5,396 2 View