What is possible cause of %rsd failure in GC Head space chromatography in six replicate standard solution??

13 March 2024 1 9K Report

% rsd fail down 10%limit

Rod's law - the more you don't tell me the more I can't help you. Your question tells me nothing. Revise it; tell us what you are doing, instrument and conditions, how you calculated your results and why you think exceeding 10% RSD is a failure.

More Shivaya shambhu Shiv's questions See All

What may be the reasons behind the shrinkage of RBC during the SEM sample preparation?

Dear researchers, I am facing a problem with the shrinkage of RBC during the SEM sample preparation. In brief, blood was collected from the fish, and the smear was prepared on a 10mm circular...

01 May 2024 7,260 3 View

Which guideline to be used for unknown peaks(Ghost Peaks)investigation and what is limit of unknown peaks in residual solvents and related substances?

During Analysis of residual solvents found An unknown peak so my question this which guideline to be used for investigation And what is limit of unknown peak in PPM And how is calculated

12 April 2024 9,510 2 View

How to estimate the concentration of a chemical compound in E3 media via HPLC?

I have to estimate the concentration of a chemical compound in E3 media used in zebrafish embryo exposure to that chemical. What should be the method or protocol for sample preparation for this ?

15 November 2023 9,751 0 View

What is the importance of whole or partial (only particular gene sequencing) mitochondrial genome sequencing of particular wild fish species?

If the species is least concern according to IUCN red list, then why we go for mt-gene sequencing? What will be the usefulness for the species after research? Would it be the useful research or we...

20 August 2023 9,663 1 View

What may be the reason behind the degeneration/degradation of 96h zebrafish larvae during the AO and DCFH-DA staining to study the apoptosis and ROS?

20-25 larvae (96h) were randomly selected, washed 2-3 times with PBS, and then stained with AO(5ug/ml) and DCFH-DA(10uM) stain for 30 min separately and then washed with PBS 2-3 times to remove...

27 July 2023 9,672 4 View

How to dope in Quantum expresso supercell ?

I wanted to dope Yttrium with 3+ valence in place of Germanium with 3+ in GaN structure. I tried to change the element in atomic positions at different points and then do relax and vcrelax. I am...

04 April 2023 9,302 1 View

Can a uniaxial elastomeric fatigue data be extrapolated to find the fatigue life of complex structures under complex loading ?

I have a a bigger rectangular block of runner undergoing simple shear deformation under axial compression. Is it correct to plot the tensile strain history of the critical point of the specimen...

13 June 2022 2,109 0 View

How to get reachable workspace of 3-DOF parallel manipulator by Monte Carlo Method?

Hello Everyone, I am working on 3 DOF parallel manipulator. I was trying to find the reachable workspace of my parallel manipulator by the Monte Carlo method, and I am facing an error in solving...

01 February 2022 4,557 4 View

What is the correct size of element to calculate T stress using CINT command in ANSYS APDL ?

I am trying to calculate the T stress from the ANSYS APDL 17.2 using CINT Command for a 2D plate under plane stress condition. The Code I am using is given below: CINT,NEW,1 CINT,TYPE,TSTRESS...

13 January 2022 2,801 0 View

How to calculate the contour integral from orphan mesh in ABAQUS?

I have created a 2D cracked plate mesh in ANSYS APDL and then imported it into the ABAQUS. I want to calculate the J integral in ABAQUS using this mesh. I have followed all the steps as per normal...

02 September 2021 5,000 0 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

Can I use a HisTRAP column for affinity chromatography?

I'm working on selecting antibodies against a recombinant protein that has a His-tag. My idea is to first bind the recombinant protein to a HisTRAP column and then use this column for an affinity...

07 August 2024 505 3 View

AUX gas reading problem on QE with full MS and PRM method in one run?

Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...

06 August 2024 4,953 0 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How can I inoculate a lyophilized anaerobic bacteria into the culture medium without an anaerobic chamber?

There are anaerobic gas pak jars and environment providers in the laboratory that provide anaerobic environmental conditions for the growth of anaerobic bacteria. However, there is no anaerobic...

05 August 2024 4,945 3 View

Why is TLC not a form of partition chromatography?

Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?

03 August 2024 7,035 3 View

Is there any Indian Company or Startups, from any universiy or IITS, which manufacture Gas Chromatography instrument , i want to make a custOmized G?

or we can collaborate

01 August 2024 6,705 2 View

Is there a good freeware software for photodocumentation of TLC?

I need something like Camag's VisionCat software for photodocumentation of TLCs. Could you recommend something?

31 July 2024 8,415 1 View