send me any article related to that
Hello,
I found this MIT news:
https://www.technologyreview.com/s/534796/nano-manufacturing-makes-steel-10-times-stronger/
And a recent research article about it:
https://doi.org/10.1016/j.jmst.2017.09.017
I hope to help you.
I want to know the specifications and details about the equipment for purchase.
10 November 2014 2,645 5 View
we tried with 1200 to 1500 rpm with feed rate of 10 mm/min kindly suggest some optimal range
09 October 2014 2,232 2 View
What are the specific requirements such as score, publications, academic percentage or any other specific skills?
09 October 2014 9,241 0 View
I think we may not do continuously or some relaxation is required to get our mind free.
08 September 2014 9,049 0 View
For material characterization like micro and macro structure observations
08 September 2014 7,746 25 View
magnesium or steel if you suggest any good materials for analysis i can look over that
08 September 2014 5,013 0 View
Infrastructure, Teaching methodology, ICT learning.
03 April 2014 2,458 3 View
It may be reciprocations/min, timing gears dimensions, camshaft type.
02 March 2014 5,999 3 View
I tested but whether it is right or wrong I got the test reports from a testing lab.
02 March 2014 1,153 2 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Is anyone here using the Thermo Fisher Nano Orange kit for protein quantification, and detecting the fluorescent signal on the Promega Quantus? We are struggling to make sense of the standard...
05 August 2024 8,946 3 View
Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container
30 July 2024 7,326 1 View
The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...
27 July 2024 8,508 0 View
Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?
25 July 2024 9,408 0 View
I have tried to saturate ferritic steel with hydrogen using the electrolytic method and H2SO4. However, the effect was very poor even after 3 days of "saturation". Can anybody help in choosing a...
24 July 2024 4,393 2 View
I am simulating interlocking / dry stacked masonry in Abaqus. I am using a friction coefficient of 0.6 for my model as it is stated in the previous research as well as in the base paper. The...
16 July 2024 5,047 0 View
In the expression for solid solution strengthening model that has been widely used in the literature use a linear form consisting of strength coefficient, and concentration of elements in wt.%....
11 July 2024 4,476 3 View
Dear colleagues, I'm currently modelling a simple 4-point bending test of a concrete beam in Abaqus. However, the load-displacement curve was ascending (without final point), which didn't match...
29 June 2024 6,192 2 View