Hello,

I'm hoping for your opinion on a problem I have.

By mistake, I left the voltage meter running for 8 min, without solutions circulation, because I wanted to shot-down the electrodialysis system but didn't notice the voltage meter.

Since then, I don't get utilization rates higher than 80%.

I changed the membrane, guessing the problem is in the system but not sure what it is exactly.

If you can help me, even send me some info about what is happening when the voltage is on but no circulation of solutions to run through the membranes, it could help.

Thank you in advance,

Rachel B.E.

Similar questions and discussions