What happen if the N2 adsorption-desorption isotherm curve of my sample not close at relative low pressure?

Septian Perwira Yudha @Septian_Yudha2

01 January 2019 0 7K Report

I send the picture of my N2 isotherm curve attached below.

Thanks for your help.

Badges
Science topic

Similar topics
Thermodynamics
Pressure

More Septian Perwira Yudha's questions See All

BET Measurement of biomass

What happen if the Nitrogen adsorption-desorption isotherm curve of my sample not close at relative low pressure? I send the picture at the attachment below. Thanks for your help and attention.

01 January 1970 6,492 10 View

Why do i have a weak plasma and no coating during rf sputtering?

I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.

07 August 2024 4,526 4 View

How to assess the osmotic power of a substance?

Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...

06 August 2024 977 1 View

In the presence of VERY high concentration (1000 ppm) of silicon, the adsorption isotherms of arsenic are showing anomalous trends, why so?

I conducted an adsorption experiment of arsenic on soil in the presence of different doses of silicon as competing ions to see the effect of silicon on arsenic adsorption and desorption. I took 5...

03 August 2024 6,500 3 View

Optimal condition for depositing FTO target 95:5% using sputter technique?

Hello I want to know about the sputtering condition of depositing FTO from target 95:5%. I tried with RF sputter in pressure 2.5Pa and 100 sccm Ar at room temperature but it showing no...

21 July 2024 1,680 2 View

What could be the possible reason that sintering of polycrystalline diamond fabricated with tape casting has suddenly started failing?

I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...

16 July 2024 3,212 5 View

The HCP removal rate is lower than usual in concentration step, why?

Hello everyone. I am working on my LV concentration porject, I use 500Kda hollowfiber to do it. The HCP and BSA removal rate is nearly 80%, but last time, I failed to run it. The HCP hasn't been...

11 July 2024 5,380 0 View

Determine pore diameter by BJH of TiO2?

Dear all, l need to help me to determine pore diameter. I got from BJH data the rp(peak area), Desorption Isotherm was 1.6 nm, but from Isotherm l got type lV with hysteresis H2 loop. Can l used...

10 July 2024 2,872 1 View

Pressure in Iron Iron Carbide?

What will be the pressure in Iron Iron-Carbide diagram? It is at atmospheric pressure?

05 July 2024 1,891 0 View

How to Perform Randall-Selitto Test (Paw Pressure Test) In Mice?

Hi All, My name is Sumaiya, a PhD student at the University of Queensland. I am looking for some suggestions on how to hold mice and perform Randall-Selitto Test by using Paw Pressure Randall...

30 June 2024 6,004 0 View

Why does a nitrogen adsorption-desorption isotherm form two loops?

BET analysis

27 June 2024 6,964 1 View