We are not getting rfd types whiteness after stripping the dyes from substrate
This yellowing is due to oxidation process and can not be avoided. Could be limited to certain extent with florescent brighteners.
Ok sir thank you
These days policy coordination is becoming necesssary on different front. In India also it is the same case. Monetary and Fiscal policy interface is important in order to address the...
30 July 2024 2,104 6 View
Though much literature suggests fitting a Voigt profile on a LIBS peak, is it also possible to fit a Gaussian profile on the LIBS peak? I have 204 spectra files, and I am building a pipeline for...
23 July 2024 6,127 1 View
This question might come up in my research on "Frustration, Fantasy, and Drug Addiction," where I'm also trying to figure out how to overcome mental health issues without turning to drugs.
30 June 2024 5,936 0 View
AGN (Active Galactic Nuclei) are high energy galaxies powered by supermassive blackholes. The evolution of a galaxy is characterized by parameters such as luminosity and redshift. The redshift is...
25 June 2024 3,782 2 View
For smoothening of noisy CD spectra, several fitting models are available in Jasco spectra manager software, like Savitzky Golay, binomial, means movement and adaptive smoothening. Each one asks...
16 June 2024 3,997 1 View
I have seeded HeLa cells in a calculation of 10000 cells per well in a 96 well plate. Then I went for treatment in the next day. Then at last, I added 7ul of 5mg/ml solution of MTT reagent into...
12 June 2024 1,460 3 View
I have 17 different steel samples, in which i identified a peak of Ti 441.492. But , if you look closely at photo, while some some peak are at 441.492 , some are at the slight offset. eg 441.490...
10 June 2024 8,934 2 View
Respected Members , I have a 17 different steel sample references , with varying concentration for Minor Elements being Mo , Ni , Mn ,Si , Cr etc , i am trying to build a calibration curve with...
10 June 2024 993 0 View
Thermal emission is temperature dependent. Non-thermal emission is not temperature dependent such as synchrotron emission.
29 May 2024 5,155 2 View
Hello Everyone ! I have a samples a satinless steel , I performed the LIBS Measurement with hLIBS (SciAps Z-300). Total of 12 measurements on different locations were done on the same sample...
09 May 2024 7,959 6 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...
08 August 2024 8,329 0 View
I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...
30 July 2024 6,420 1 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,714 4 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,227 2 View
Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...
28 July 2024 5,771 2 View
Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?
27 July 2024 648 3 View
Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...
27 July 2024 5,748 0 View
It has been long known that EDC carbodiimide and NHS easter's half life agains hydrolysis are highly related to pH. However, very surprisingly, not yet found a paper giving a table/chart of their...
25 July 2024 8,738 0 View
Hi there, I'm new to modelling with comsol. I would like to ask if it is possible for comsol to output linearly polarized (LP) modes? I tried modelling a simple single mode fiber with an enlarged...
23 July 2024 4,019 3 View