Dear Reader,
Recently, I have prepared a polymeric nanofiber using PVA polymer doped with some nanoparticles and I want to find out its microhardness. So, I was planning to do nanoindentation characterization. The nanofibers were fabricated by electrospinning method and it was obtained as a thin layer coated on a glass substrate, the thickness of the nanofibers was found to be in the ranges 31 nm to 120. As I am expecting meaningful results, what could be the appropriate load and loading rate to carried nanoindentation on the nanofiber?.
Thank you
For nano indentation read the paper
processing instruments.........pu/bentone coatings
Balwinder Singh Ghuman thanks a lot for your reply and suggestion. I believe that these parameters will give a good and interpretable result.
Balwinder Singh Ghuman Sir, I need one more clarification about the loading function for applying the said loading rate. What could be the probable loading function?
read that paper 'processing instruments......
............bentone/pu coatings
- Badges
- Science topic