Hello,
I work with root lesion nematode resistance in barley. For that, I need to perform resistance test under the greenhouse conditions. I have a DH population that I grow in the greenhouse.
Seeds were germinated on wet filter paper at 26°C for 1 day in the dark. Each seedling was placed in a 20 cm3 tube [12 cm (H) × 2 cm (∅)] filled with steam‐sterilized sand. A 20‐μm sieve, fixed at the bottom of the tube, prevented root outgrowth and inhibited nematode loss. The tubes were filled with heat‐sterilized sand and wetted with nutrient‐rich water until they were fully soaked before sowing. The tubes were placed in special holders in the glasshouse on an irrigation system.
The plants were fertilized with a nutrient solution as described by Marshall and Ellis (1998) with the following modifications (g/l): 1.40 g Ca(NO3)2 × 4·H2O; 0.11 g NH4NO3; ; 0.29 g K2HPO4 × 3·H2O; 1.5 g K2SO4; 0.96 g MgSO4 × 7·H2O; 0.96 ml trace element solution. The pH value in the solution was adjusted to 6.4 with 25% sulphuric acid.
Light conditions in the greenhouse: long day conditions (16h light, 900 μmol m-2 s-1, Son-T Agro 400 W, Koninklijke Philips Electronics N.V., Eindhoven, Netherlands)
Problem: As shown in the picture, the leaves are turning yellow. The yellowing process starts from the tip of the leaf and then it spreads over the whole leaf, eventually killing the plant.
Any ideas how I can solve this problem?
Thanks in advance.
-Smit