Please, beside the in-cylinder pressure, what are the other sources of noise in diesel engine?
What are the factors required for the deployment of elctric trains in a state?
04 May 2018 5,651 2 View
Please we wish to carryout Atomic Absorption Spectro Photometry on Jets Fuel, what are the likely conditions, we are afraid of the inflammable nature of the fuel
02 March 2018 2,313 1 View
Please I am looking for a good and resourceful materials that described convective heat transfer in turbulent flow.
02 March 2018 3,155 9 View
Which additive is the best for bio based lubricants meant for engine oil lubes, and which one is the best for bio-grease? What is the implications of not using additives on the lubrication efficiency
01 February 2018 7,692 5 View
Please I am looking for a simple method or explanation on how to interpret Fourier Transform Infra Red Spectrometry Results
11 December 2017 9,267 5 View
Can anyone help me with an exhaust emission modelling software
01 January 1970 2,990 2 View
Please can anyone help me with this books: 1-How Round Is Your Circle?: Where Engineering and Mathematics Meet 2- Approximating a circle with a polygon Thank you
01 January 1970 1,097 0 View
May I get a link with any manufacturer of metal pipes that have cooling fins meant to be used for exhaust flue gases of an automobile?
01 January 1970 9,023 4 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...
06 August 2024 977 1 View
The threshold voltage (Vth) of a MOS device plays a crucial role for its operation. At the same time, noise is an intrinsic factor. So how noise (flicker or thermal) change with the change in...
29 July 2024 3,246 0 View
Hello I want to know about the sputtering condition of depositing FTO from target 95:5%. I tried with RF sputter in pressure 2.5Pa and 100 sccm Ar at room temperature but it showing no...
21 July 2024 1,680 2 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
Hello everyone. I am working on my LV concentration porject, I use 500Kda hollowfiber to do it. The HCP and BSA removal rate is nearly 80%, but last time, I failed to run it. The HCP hasn't been...
11 July 2024 5,380 0 View
What will be the pressure in Iron Iron-Carbide diagram? It is at atmospheric pressure?
05 July 2024 1,891 0 View
Hi All, My name is Sumaiya, a PhD student at the University of Queensland. I am looking for some suggestions on how to hold mice and perform Randall-Selitto Test by using Paw Pressure Randall...
30 June 2024 6,004 0 View
I would like to dedicate my entire life in doing only one activity alone and nothing else. How do I achieve it in this world full of unavoidable distractions and societal pressures?
24 June 2024 298 1 View
While deriving for a momentum equation with elastic stress effects, I am planning to put a ratio between elastic modulus (in Pa) and dynamic pressure (in Pa) in a simplified form. I am not...
23 June 2024 8,059 1 View