Please mentions the proper ratio of both ZnO and PVP.
Dear Yogendra Yadawa, it depends essentially on the polymer MW and the final properties. A lot of work was done on this binary system. Plrase check the following documents. My Regards
https://www.researchgate.net/publication/236965743_Luminescent_polyvinylpyrrolidoneZnO_hybrid_nanofibers_membrane_prepared_by_electrospinning
https://link.springer.com/article/10.1007/s10854-017-7688-6
https://doi.org/10.1016/B978-1-4557-3159-6.00013-4
https://link.springer.com/article/10.1007/s10854-017-7688-6?shared-article-renderer
https://doi.org/10.1080/01932690903212222
https://doi.org/10.1016/j.mssp.2015.08.003
https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4049438/
https://doi.org/10.4028/www.scientific.net/MSF.888.309
Please check this manuscript. I hope it will help you to optimize the perfect concentration for your ZnO and PVP.
Do you mean stoichiometric proportion ? It will depend upon the aspect ratio of the fibers.
How the EDX results significant with the stoichiometry? Please anyone explain this and provide the appropriate references?
06 November 2023 7,198 3 View
Can any one help me in this regard - Molecular characterization of bifidobacterium by AFLP ? or RFLP?
26 June 2023 1,052 1 View
I am doing research on probiotics and prebiotics, now looking some specific strains like Bifidobactirum, Lactobacillus and in this regarding need some information regarding isolation and molecular...
11 March 2023 2,998 2 View
In order to calculate trans-membrane pressure(TMP) of a dead-end ultrafiltration unit, how do we measure pressures at inlet and outlet?
25 October 2021 3,581 3 View
Which solvent is best to make a suspension of ZnTiO3 nanoparticles for FTO/ITO glass substrate coating to perform the electrochemical water splitting test.
23 May 2021 3,055 2 View
Category: Maximum number of research papers published in non-paid "Science Citation Index Expanded (SCIE)" indexed journals in any one year as a single-author.
10 March 2021 4,305 2 View
Please give the proper answer and how it is performed. Provide a short demo video if as soon as possible.
15 September 2020 989 2 View
I have 607 sample size of 48 items for four variables. My model fit summary shows CMIN/DF=2.910, CFI=.886, GFI=.842, RMSEA=.056, SRMR=0.049, PClose=0.000. I am not being able to get my model fit....
29 August 2020 4,001 8 View
I am trying to compute Gini Coefficient for groups in a single table to demonstrate inequality among several groups based on consumption or other variables. I have about 90 groups to look at...
05 February 2019 1,502 3 View
I think a paper published in ‘IEEE Transactions’ having low impact factor has greater value than a paper published in a high impact factor SCI journal.
30 November 2018 4,542 2 View
I have been working on Red blood cell-derived extracellular vesicles as Antisense Oligonucleotide (ASO) carriers. We normally run agarose gel to quantify the loading efficiency. I used naked ASO...
06 August 2024 3,130 2 View
I have been using paraffin, but the deposited ZnO still detach from electrode. What is the best binder to modify graphite paste electrode with ZnO nanoparticles?
03 August 2024 4,624 3 View
It's an end-point PCR protocol. I'm using 1.5% agarose gel with SyBR Safe dye and TBE as a running buffer, visualization on BioRad XR+ system. I was primarily thinking of primer efficiency,...
01 August 2024 4,673 4 View
Dear all, I have noticed, as the ZnO content increases, the Raman intensity at 100cm-1 also increases. However, there is a peak nearby at 130 cm-1, which I could not find in any paper related to...
28 July 2024 5,410 1 View
How can the rubber fibres produced by the electrospinning device be removed from the fibre collector (aluminium foil) without affecting the orientation of the rubber fibres for use in reinforcing...
26 July 2024 8,281 0 View
Greetings. I’m currently running a nested pcr for giardia. My mastermix comprised of 3mM Mgcl2, 5unit of taq polymerase, 0.2uM of forward and reverse primers each respectively and 0.2mM of dNtp...
22 July 2024 9,761 5 View
I’m having difficulty achieving high RNA integrity in my samples. Although the 260/280 and 260/230 ratios are satisfactory after RNA extraction, the RNA samples show signs of degradation when...
22 July 2024 155 4 View
Sometimes I see the shadow like bands and its not true band. I want to know that what's the reason for it. I am using 2% gel for running genotyping samples I have uploaded the gel picture in both...
19 July 2024 148 6 View
Recently I have submitted an article regarding MB dye degradation by ZnO nanoparticle. I received a suggestion to include the discussion on the effect of pH. I want to know what is the impact of...
19 July 2024 4,868 1 View
I have been running native page for FAM DNA substrate ( fluorescence samples) for protein DNA binding reaction. Binding is there but towards the end of the lane , I am loosing signals...
17 July 2024 6,213 4 View