Are there large area OPV modules based on P3HT that have power conversion efficiencies above 5% been produced?

10 November 2016 956 1 View

In the case of solar cells, what are the best routes to couple energy to the active material for energy harvesting?

One of the key requirements to improve the efficiency of solar cells is to be able to couple the energy from the external source to the harvesting device in the optimum manner. For this you need...

09 October 2016 2,136 3 View

How can we better decouple carrier transport in CVD grown graphene from the substrate?

There is much research being conducted on growing high quality CVD graphene on substrates that are important for the microelectronic industry, as well as processes that will allow for the transfer...

05 June 2015 5,027 0 View

Have you observed iridescence from elecrospun carbon nanotubes or nanofibres? We do, in well aligned CNT films!?

This is observed in the material produced in our well aligned materials in:...

01 February 2015 8,171 2 View

What is a good way to define the 4th Generation of solar cell technology?

06 July 2013 9,226 5 View

SDS page software for analysis?

I did sds page to determine the difference in protein expression between 3 types of vaccine , but i don't have scanner or densitometer available. . so i wonder if there is a software to analyze...

02 March 2021 6,270 3 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Any research papers for extraction of nutrient deprivation on macroalgae? Analysed by HPLC-UV and GC/MS. Possibly from macroalgae genus Rhizoclonium?

I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...

28 February 2021 6,477 1 View

Do I need to ask permission to use pictures for my questionnaire?

I would like to use some photo from a government website for my questionnaire. But, different photo is from the different owner. So, should I just get permission from that government body or still...

23 February 2021 1,631 3 View

In methylene blue test Why is UV absorbance reading very low as soon adsorbent is added and then increasing before reaching equilibrium?

Hello, I'm working on removal of methylene blue. 01. in the dark test very first reading is taken 15 minutes after adding adsorbent to the dye solution and that UV absorbance reading is very...

19 February 2021 472 5 View

No title

The regenerated cellulose film was prepared by zinc chloride/H2O system. The zinc chloride had been washed away in the regeneration process, and the wet film which was not dried had uniform...

18 February 2021 9,538 1 View

Onset of Photo Oxidation in Polymers?

Hi! I am looking for some specific information in regards to the minimum amount of UV intensity required to begin the photo degradation process in polymers. I understand each polymer is...

15 February 2021 7,703 4 View

ZnS oxidizes to ZnO!!why??

when I put my ZnS solution in the chemical bath, the ZnS oxidizes so there are ZnO peaks appearing because of the reaction with the oxygen in the air, despite the fact that I close the beaker...

14 February 2021 5,778 9 View

How to determine the drug loading and the drug release capacity of a polymer micelle using UV spectroscopy?

Currently, I am working on PLA-PEG copolymer micelle for the drug delivery system. I have seen several papers where some researcher talks to centrifuge the drug-loaded micelle to separate the...

13 February 2021 5,822 7 View

What is the UV-vis spectroscopy and HPLC UV detector?

I did spectrum scan to levothyroxine sodium which show highest absorption at wave length=230nm which the absorption =0.136 and it's absorption at 225nm =0.047 but when Injecting it on HPLC...

09 February 2021 1,631 3 View