Apart from machining technique, is there any other method through which cladding material can be removed from the surface of metal sheets?
grounding with abrasive paper, or sandblasting
Using grinding machine
Thanks for your suggestions
Does electromigration have adverse effects on conductive metals (with reasonable girth) other than thin-film metals, semiconductors or integrated circuit chips?
31 December 2018 4,910 3 View
I have been trying to simulate a FSSW process but I keep getting the error given below. Likewise, I have applied the needed BC to effect the changes it suggested but all to no avail. Please, I...
10 November 2015 10,013 3 View
I am trying to simulate a FSSW process but the above/below errors keep on emerging. I have applied adaptive ALE to try and eliminate the issues but the errors remained after submitting the job. I...
10 November 2015 4,613 5 View
I am trying to run explicit simulation of friction stir spot welding (thermo-mechanical coupling analysis). The errors are stated as follow after job submission. Error in job FSSW: Zero or...
09 October 2015 6,325 1 View
Hello, colleagues. Recently, I have been working on a metal processing simulation with my UMAT in Abaqus. I have outlined the corresponding simulation, but I keep encountering issues that cause...
30 July 2024 7,062 1 View
Hello Everyone! I am trying to create a metal hydride system where I am trying to create a temperature control with the emphasis on measuring the concentration of the hydrogen with the hydrogen...
29 July 2024 7,577 2 View
Understand how to utilize biosynthesis to develop natural and sustainable solutions to address heavy metal pollution and improve environmental and agricultural conditions.
26 July 2024 1,469 1 View
I am trying to coating metal oxide into steel substrate, for better sticking planning to utilse epoxy based, Could you please suggest suitable curing agent for the coating purpose
25 July 2024 438 3 View
I intend to get an economical and accurate LAB TEST to measure arsenic concentration in blood sample.
23 July 2024 3,654 2 View
I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...
22 July 2024 3,490 2 View
Can the mode volume in smaller metal nanoparticles be larger than the nanoparticle volume?
18 July 2024 4,859 4 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...
13 July 2024 9,003 2 View
What is the best method to distinguish and identify metal nanoparticles dispersed in water, given their very small size ( 3-5 nanometer ), while ensuring that the method used does not alter or...
10 July 2024 9,924 2 View