What is the reason for high flowability and low viscosity for Bimodal PSD and Broad PSD curves?

What is the reason for high flowability and low viscosity for Bimodal PSD and Broad PSD curves?

01 February 2017 6,816 3 View

Are there any issues for adding dispersants with sodium salt?

Are there any issues for adding dispersants with sodium salt?

31 December 2016 1,384 1 View

Is there a way to improve the hardness and toughness of available SiC macro grains?

Are there any chemical or mechanical treatments? Grains are in mm range

08 September 2016 3,792 0 View

Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

Ester cleavage conditions?

Hi all, I need to cleave the ester in Ethyl 2-amino-1H-imidazole-5-carboxylate to make the carboxylic acid and retrieve the product from solution to use in downstream applications of linking to...

01 March 2021 8,766 3 View

How to remove the residual PDMS on the silicon mold?

Incompletely cross-linked pdms are difficult to remove.

01 March 2021 798 3 View

Can't recognize exact phase and PDF card no of Silicon carbide in XRD?

We have deposited silicon carbide on carbon substrate using one PVD technique. Due to amorphous behavior of SiC at low deposition temperature, we performed heat treatment of those films at...

22 February 2021 2,072 3 View

Amorphous silica XRD peak at around 10 degree?

21 February 2021 3,417 5 View

What is the detection limit of ED-XRF technique for transition metals in silicon ?

Hi everybody, please, can someone tell us if the transition metals (W, Fe, Ni, etc ...) in silicon destined for solar cell manufacturing can be detected by ED-XRF technique. Note that the...

18 February 2021 6,231 4 View

Could you please share your experience with me on the type of 96 wells plate for MIC determination: Treated Vs Untreated and Round-Vs Flat-bottomed?

I am working on the MIC determination of various antibacterial agents (both water-soluble and- insoluble) against S. aureus, MRSA, and S. pyogenes. Some guidelines recommend using round-bottomed...

17 February 2021 7,029 3 View

How to predict the reaction pathway for electro organic synthesis?

Can anyone recommend some any software/models available that can predict substance reactivities and the reaction yield under a specific set of reaction conditions process and proposing pathways to...

17 February 2021 2,383 3 View

Unusually Busy Raman Background?

Hello, I am observing a nearly periodic background spectrum for a wide variety of SERS substrates. I see this response (attached below) for bare Au films, Cu films, and Au nanoparticles on...

15 February 2021 9,922 5 View

Glucose 6 phosphate dehydrogenase deficiency & NSAIDs - is this combination harmless ?

G6PD deficiency is quite common in our anesthesia practice in the middle east. Intraop/postop analgesia in them is an issue here. Many websites/books give contrasting advise with former advocating...

10 February 2021 4,817 3 View