What are the major impacts that results from connecting different renewable energy source to the grid on both grid connected mode and island mode?

What are the major impacts that results from connecting different renewable energy source to the grid on both grid connected mode and island mode? describe the operation of connecting different...

03 April 2018 8,783 1 View

What is the latest method of controlling using AI for the renewable energy system?

What is the latest method of controlling using AI for the renewable energy system? I need some of intelligent control techniques for renewable energy system

03 April 2018 1,353 2 View

What is the main function of the power electronics interface (interlinking converter) between the DC and AC micro grids?

what is the main function of the power electronics interface (interlinking converter) between the DC and AC micro grids? describe main function of Interlinking converter,structure , matlab simulink

03 April 2018 1,596 3 View

What is the recommended block diagram of WECS connected to the grid through AC bus?

what is the recommended block diagram of WECS connected to the grid through AC bus? i need block diagram of WECS connected to the grid through AC bus and different blocks diagrams of GSC control...

03 April 2018 4,240 3 View

Are there any equatios that describe behavior of circuits during fire?

I need different equations that describe the behavior of electrical circuits during fire. just before fire exist, during fire and after fire . is it depends on resistance or cross- section or...

01 February 2018 2,037 2 View

what are the most widely used energy storage types in renewable energy systems?

05 June 2015 7,179 2 View

What are different modes of operation for renewable energy sources connected to DC bus or AC Grid or both with different loads?

what are different modes of operation for renewable energy sources connected to DC bus with different loads? and are theses different if connected to Ac bus or AC grid? or both?

05 June 2015 9,270 3 View

Is it important to add ESS with renewable energy sources connected to the grid?

is it important to add ESS with renewable energy sources connected to the Gird such as supercapacitors , batteries or fuel cells

03 April 2015 8,313 3 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

In Molecular Dynamics Simulation, how do I make changes to the force field according to my protein?

Hi In Molecular Dynamics Simulation, how do I make changes to the force field according to my protein? I got this error in the add-ion stage: Fatal error "./ amber99sb-ildn-HHH.ff / force...

01 March 2021 8,747 4 View

What is Flat Lens Antenna?

28 February 2021 5,433 3 View

Can impedance of antenna be less than 50 ohms?

I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...

27 February 2021 4,218 7 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

How to calculate battery consumption for IoT device?

Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...

25 February 2021 8,749 6 View

How to troubleshoot Electrochromic Films and Electrochromic Devices?

I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...

23 February 2021 9,592 2 View

How to include additional force field in GROMACS?

I have a cellulose model system that is best described by the GLYCAM06 force field according to the literature. However, the set of force fields included in the GROMACS package doesn't include the...

20 February 2021 3,309 3 View