Use of PIM-modified membrane in ethylene/ethane separation?

12 February 2018 0 4K Report

Separation of ethylene/ethane was difficult can I use PIM membrane to do that in industry field ?

Badges
Science topic

More Fathi Elathrem's questions See All

What is the role of artificial intelligence in psychological and social crises?

As technology races forward, AI is proving to be a powerful resource in tackling mental health and social issues. Early Warning System: AI can analyze data to predict mental health crises before...

29 March 2024 2,425 2 View

In the field of training and improvement of human resources through MOOCs, which research gap is more significant?

Hello. good time By answering this question researcher, you can help her a lot

26 December 2023 5,847 3 View

I am looking for a postdoctoral position in Agronomy. Is it available?

I am looking for a post doc. position on plant nutrition, stress physiology or climate change in agriculture. I thank all the scientists and researchers who can help me on this topic. Regards Amin

03 October 2023 4,495 1 View

How to analyze 2d and 3d Crack under Periodic Loading in Abaqus?

Hi, I want to analyze a crack in 2d and 3d and find displacement of the Part Block due to that Crack and loading. My question is as I want to create periodic Sine load applying for several second...

21 July 2023 7,212 0 View

Dear researchers and inventors, I would be grateful if you do favor and let me know for sailing my US patent . What route do you suggest?

I have an US patent and tend to sale it.

29 June 2023 3,794 1 View

Any researcher has this antibody for Immunohistochemistry TRPC5?

For mouse

20 June 2023 8,435 2 View

Hello everyone I have a question, about bubbles in resin epoxy?

hello everyone I have a question, I want to make a multi layer composite with epoxy and fiber mat with hand lay up molding. one of my problems is bubbleshello everyone I have a question, hello...

18 June 2023 3,073 0 View

What are the main components in making organizational intelligence?

Hello, dear researchers The main components that I have obtained so far from the sub-components include organizational agility and flexibility, organizational innovation, and knowledge...

07 June 2023 8,897 6 View

How to synthesize an highly stretchable (at least 100%) polyurethane sheet?

Which combination of polyol and isocyanate can be used to synthesize a stretchable (at least 100%) polyurethane sheet/film? I have tried monomeric and polymeric MDI along with Castor oil as well...

05 June 2023 8,826 2 View

Comparison between different HVI?

Dear collogues, I'm planning to porches HVI (high volume instrument) for our department fibre quality lab. we have got two suggestions, STATEX HVI and HVT Genius 2+, beside of the price which one...

02 June 2023 4,051 0 View

Ethylene glycol is newtonian or non newtonian fluid?

Some sources say it is treated as Newtonian as ethylene glycol has a higher viscosity than water, which affects the flow characteristics in simulations. But some also say it is non-Newtonian.

09 August 2024 2,111 2 View

Synthesis of CaFeO3?

I have synthesized CaFeO3 three times using metal nitrates through sol-gel method but each time XRD analysis show that its peaks match with Ca2Fe2O5. Metal to acid ratio is 1:1.38. I've also tried...

25 May 2024 3,346 1 View

Why does cyclic voltammetry not stabilize after 100 scans for ethylene glycol?

I did the CV at a speed of 1V.s-1 and 100 sweeps, and even then the current value did not stop increasing. Will I need to do more scans (for example 500) until it stabilizes? Or is this a...

06 May 2024 8,340 0 View

Can anyone guide me on how i can measure ethylene concentrations for making a calibration curve using GC with FID and what kind of coloumn will work?

How can I make a vacuum chamber with glass jar to measure ethylene gas concentration using GC in lab scale? And how can i do serial dilution of pure ethylene gas for calibration curve?

04 April 2024 6,432 0 View

Does anyone know what concentrations of Ethylene oxide soln is low enough to dispose in sink? <=1ppm?

I am validating a GC-FID analytic method to quantify residual ethylene oxide in medical packs. Hence was wondering what concentrations of Ethylene oxide solutions were low enough to dispose down...

04 April 2024 9,650 1 View

Why does my clay contract after glycol treatment for XRD analysis?

Recently in my lab I’ve been trying to expand some Muscovite following two different protocols. I use XRD to verify the d-spacing after the treatment without ethylene glycol and with ethylene...

18 February 2024 3,608 0 View

Can diethylene glycol be substituted with ethylene glycol in microwave-assisted polyol synthesis of carbon quantum dots?

Using the microwave-assisted polyol method, I'm carrying out a project that uses folic acid as a precursor to synthesize carbon quantum dots. Is it possible to substitute DEG, usually used as the...

06 February 2024 7,128 1 View

How to dilute ethylene gas (1%) to make ethylene standard curve in GC?

I have an ethylene gas (1%) cylinder balanced with Nitrogen. Cylinder volume is 1.55 L. I want to make a standard curve with very low concentration of ethylene, in nano litres. How do I dilute the...

29 January 2024 8,857 0 View

How to melt ethylene carbonate (EC) solvent for the preparation of sodium electrolyte?

Hello, I want to prepare NaPF6 : EC/DMC electrolyte for Na-ion battery. I have EC solvent but in a large aluminum bottle of 1L (Sigma Aldrich). I tried to heat the bottle on a hot plate at 80 °C...

28 January 2024 2,202 1 View

Zirconium Oxynitrate solubility is higher in water or ethylene glycol,???

15 January 2024 2,360 0 View