Unable to separate well by centrifugation?

10 November 2018 0 867 Report

I put the V2O5/GO 0.1g (after calcination) into 50g of 95% ethanol and 50g of deionized water. It is difficult to pass the centrifugal separation again. Is there any reason or improvement?

Badges
Science method

More Han-Ching Jao's questions See All

How to make ppb level concentration ?

Hi, I've N2 gas cylinder and 100 ppm NH3 gas cylinder. With these two cylinders, I'd like to make a ppb level (1- 100) concentration. Any idea how to do that?

01 February 2021 3,264 2 View

What will be the possible reasons to cause no bands on gel electrophoresis?

Hi, I am doing RNA extraction for my final year project. After extraction of RNA by using conventional method, I did quantification and qualification of RNA by using Nanodrop spec and gel...

11 January 2021 8,775 10 View

After CRISPR and single-colony picking, cells reverted to WT?

Hi guys: I have been doing CRISPR knock-in and knock-out and one seemingly impossible scenario keeps happening. In the CRISPR knock-in attempt I tried to add a tag on a gene of interest, so I...

07 January 2021 190 3 View

How to increase the attachment of the HEK293t cells to the glass coverslips or cell dishes?

Hey guys, I always have problems with the attachment of HEK293t cells to glass coverslips while doing IFA. They are so easy to detach from the coverslips while washing. The coverslips are already...

30 December 2020 8,381 3 View

Can anyone advise me on how to amplify V4 region of fecal DNA of dss-induced colitic mice for microbiota profiling?

Animals were fed DSS via drinking water and fecal samples were collected and DNA was isolated using Qiagen stool DNA isolation kit. The V4 region of extracted DNA was amplified with specific...

20 December 2020 1,739 3 View

Looking for a glass slide with very low Autofluorescence (GFP)?

Does anyone know any glass slides (thickness 0.1 to 1mm) that have very low autofluoresence (GFP). I am doing a very sensitive experiment that require my glass substrate to be as low fluoresence...

28 November 2020 1,917 6 View

How can I set to thin film on the substrate in ZEMAX?

My research is about 3D-printing add nanoparticles attach to copper. So I'm trying to use ZEMAX to calculate absorption, someone knows how to set the thin film on ZEMAX? Have any suggestions or...

26 November 2020 7,200 1 View

Function of SDS in Northern Blot washing step?

In Northern blot, we normally use either 2*SSC+0.1% SDS or 0.1*SSC+0.1% SDS in washing step. Does anyone know what's the function of the SDS in the washing buffer? Thank you in advance

26 November 2020 2,432 1 View

How to calculate the analytical solution for the HYDRUS-3D model simulation of water and salt movement in soil?

Suppose an agricultural field with uniform soil texture and salinization. The groundwater depth is 20 meters, assuming that the depth of the groundwater and the concentration of salts remain...

25 November 2020 2,382 4 View

Protein concentration decrease after dialysis?

Recently I have been involved in this problem: After expressed by adding IPTG, lysed with B-PER, and resolved with Buffer B (8M urea), incubate with Ni-NTA beads, everything looks fine. When I...

21 November 2020 7,416 3 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Does any one can help me choose a reasonable basis set for intermediate metal ions interactions with guanine (i.e Fe2+, Mn2+, Cu2+ and exc.)?

Hello every body Does any one has any idea to help me choose a reasonable basis set for intermediate metal ions (i.e Fe2+, Mn2+, Cu2+ and exc.) interactions with guanine or other DNA organic...

01 March 2021 6,187 2 View

What could be some reasons why unstimulated monocytes are getting activated?

Im doing PBMC isolation -> CD14+ enrichment using magnetic beads -> stimulation setup. My negative control is just cells in cRPMI but they seem to get activated over and over again.

28 February 2021 7,883 3 View

Why does intensity drops as concentration increases?

Is there any reason for decrease in fluorescence emission intensity of HSA,BSA when increase the concentration ?

28 February 2021 3,653 4 View

POlymer+DMSO solution and moisture??

What could be the reason of moisture at the sides of Vial when I am preparing my polmyer+DMSO solution for membrane fabrication? What etiquettes I am possibly missing here?

28 February 2021 6,516 5 View

Should we reduce the standard unit of length to 0.31951540592 meter ?

The reasoning behind this question is to align the ratios of the proton potential in energy per charge to the speed of light in distance per time. As these two dimensions appear to be related,...

27 February 2021 947 7 View

What could be reason for getting such type of graph for complex impedance in case of polymer blend films?

Its effect appears in real part of ac conductivity also. Can anyone suggest any reason behind it?

26 February 2021 3,487 3 View

Zno nano particles colour changed from white to grey in process of calcination any suggestions?

In the formation of Zno nano particles process, after drying at 120 degree C, my zno nano particles are completely white but when i calcine it for 450 degree C it converts into grey colour. i...

26 February 2021 2,435 4 View

Quantifying leaking DNA from bacteria - what's the secret?

Hi, all! I need to determine if my treatment causes membrane damage in bacteria (S. aureus and E. cloacae), but I cannot use a fluorescent probe such as PI and similar ones because my compound is...

24 February 2021 2,006 2 View

How can I verify my centrifugal fan design for electric motor cooling?

I have radial blade centrifugal fan design which will be mounted on exhaust side of electric traction motor. The fan will be mounted on same motor shaft inside the housing. How can I verify that...

23 February 2021 2,390 3 View