I am trying to edit hydraulic conductivities using a selection of a specific storage area. I never used multiple assignment. What I did was:

1st - selected specific storage in panel Data

2nd - defined a selection

2nd - stored the selection

3rd - selected conductivity in panel Data

4th - activated the stored selection

5th - edited the conductivity values in the area of that selection

FEFLOW edited the values... but reshaped completely the distribution of ALL other properties. So now I have my conductivity OK but all my other properties have just 2 areas with 2 values in the whole domain of the model.

Can someone out there tell me how I solve this problem?