Dear researchers, Could you please explain why the GCD curves looks this way? especially the one at 8 ma
i thought it should be fully rectangular for EDLC
i am using fly ash carbon
Dear Oussama Khiter ,
illustrate your cell (thoroughly, and the substrate).
thank you very much Dear Ioannis Samaras , here i am using fly-ash activated carbon coated on a graphite sheet as an electrode, and 1M of KOH as an electrolyte.
so, we can find, actually, two[1]-WEs: 1)fly-ash, and/on 2)gr-sheet, the substrate.
What is the CE (and the RE) ?
Recommendation: Try a CVL and/or an EIS (as diagnostic tests), and/or a new GCD under a much lower-i (i
Dear Ioannis Samaras ,
thank you very much, i will redo tests.
Hello I am conducting a microstructural analysis of a soil treated with lime. The following sem images are of the untreated s1 and treated soil s3. The untreated soil contains quartz calcite...
01 August 2024 572 0 View
Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...
26 July 2024 9,156 2 View
Hello How can I get the velocity plot u(t) of a rising bubble using COMSOL like in this tutorial...
24 June 2024 9,441 6 View
There exist a wide range of technologies used for energy storage such as electrochemical (batteries), electrical (supercapacitors), mechanical,...etc. What are the best and the most efficient...
17 May 2024 3,412 1 View
Why specific capacitance calculated from cyclic voltammetery is different from the one calculated from charge-discharge? Ps1: I used the same potential window. Ps2: the charge-discharge curve is...
18 April 2024 9,691 1 View
How much water is typically used during the impregnation step? is there any relationship between the weight of carbon and the amount of water?
12 April 2024 2,952 0 View
What is the best approach to design an H infinity controller for a linear model of a wind energy conversion system, with the goal of simulating it in Simulink? Any specific methods or tools...
26 March 2024 4,008 1 View
Dear researchers, during chemical activation, when should i start injecting N2 to the precursor? is it at the same time when start heating or until reaching the desired temperature ? thanks in...
23 February 2024 1,307 9 View
the furnace i am using for activation has been damaged, the alumina tube broke , i need a good glue to fix it!
12 November 2023 5,248 1 View
during GCD, i am seeing no discharge after long time of charging?
12 November 2023 7,295 12 View
I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...
10 August 2024 3,629 1 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
How do interactions between the biosphere, the carbon cycle, and the water cycle impact global warming and interaction between the atmosphere and the hydrosphere?
09 August 2024 3,291 2 View
How to develop investments in renewable energy sources?
08 August 2024 5,112 3 View
For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...
06 August 2024 3,176 0 View
Global ‘Weather’ has stopped, as ‘aqua thermionic instituted by the ‘Global thermo atmospherics has instituted global thermodynamics of 120º C + and thus all waters are, or have boiled into a...
06 August 2024 8,716 0 View
Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...
05 August 2024 3,783 2 View
Samuel Morse, the inventor of the Morse Code, understood that certain letters in the English language occurred more frequently than others (Gallistel and King 2010). To deal with this, Morse used...
01 August 2024 4,456 2 View
Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...
30 July 2024 9,824 2 View
The starting material is a finely ground powder. Some particles contain more graphene than others.
30 July 2024 3,978 2 View