Thermophysical data for water sodium sulfite (IV) solution

More Łukasz Wieczorek's questions See All

Material, energy and momentum balance literature

Can anyone suggest some position in literature with wider insight on material, energy and momentum balance, both in general and particular cases?

04 May 2013 5,419 4 View

What size could a single cyclonic wet scrubber reach?

I'm asking especially according to height dimension.

04 May 2013 8,249 1 View

How to predict overall diffusivity of each component of the liquid solution of NaOH, Na2SO3 and NO2?

I'm working on absorption of SO2 and NO2 with chemical reaction in NaOH solution. To make it easier, the reaction with NO2 does not exist, and only the reaction SO2+NaOH-> proceed irreversibly and...

01 February 2013 7,733 1 View

How to get diffusivity of water in electrolytes.

The diffusivity of electrolytes in water could be easily obtained, however, when the multicomponent matrix is to be created, both binary diffusion coeficients are needed. Does anyone know an...

01 February 2013 2,486 1 View

Aqueous sodium sulfate viscosity

Does anyone know any data for aqueous sodium sulfate viscosity in range of 0 to 100°C?

01 February 2013 4,763 4 View

In which cases is the diffusivity of an electrolyte in solvent the mutual diffusivity?

Both solvent in solute and solute in solvent?

01 February 2013 476 5 View

Does anyone know of correlations between Falkenhagen relations parameters and temperature? Or do you know of alternative ways of predicting visco in electrolyte sol.?

Falkenhagen relations are for the prediction of viscosity of electrolytes. This book presents the method...

31 December 2012 4,013 0 View

Density and viscosity of sodium hydroxide solutions

I'm looking for correlation for density and viscosity of sodium hydroxide in function of concentration and temperature in range of 0-140 degrees Celsius?

31 December 2012 288 7 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Best mask design for metal deposition aiming build a Perovskite solar cell device?

What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?

31 July 2024 4,835 3 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

What is the best method to detect the chemical composition of pollen ?

I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?

28 July 2024 5,331 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

Xiangxi Meng

If precission is not so important, I would suggest you try to estimate with empirical equations, such as UNIQUAC

Łukasz Wieczorek

How can I do so? I'm not so familiar with UNIQUAC yet. I only know that UNIQUAC can estimate acitivity coefficients. I don't much care about accuration, any solution is required. I'm in emergency now, out of time and need some quick solutions.