Thermal conductivity values of nanofluids with terminol base fluids?

More Berkan Koç's questions See All

Could someone be of assistance to help us use Amazon Turk in our cross-cultural research?

Amazon Turk is available only in certain countries. Could someone be of assistance to help us use Amazon Turk in our cross-cultural research? We will be paying all the fees associated with the...

27 July 2023 7,589 3 View

How to calculate thermal conductivity values of heat transfer fluids based on therminol?

Where can I find the physical property formulas of terminols as in the picture I shared. Therminol 66, Therminol 62, Therminol VP-3, Therminol....(for all therminol heat transfer fluids)

27 April 2023 9,517 3 View

How can I find the "sodium pentaborate refractive index" number or does anyone know?

28 November 2022 8,501 0 View

Southern blotting - why is low-stringency wash used?

I have a question regarding the hybridisation step in Southern blotting. I understand that once the probes are added, the membrane is washed in buffer of increasing stringency to increase the...

17 November 2022 961 1 View

What are the differences between 20 kHz and 100 kHz initial frequency in EIS?

I want to measure the impedance of a microbial electrolysis cell. In the literature, they usually set the initial frequency to 100 kHz however, the potentiostat we have is limited to 20 kHz. What...

17 November 2022 1,748 2 View

Is it possible to have an binary indepedendent variable with two-levels for mediation?

Hi everyone! I would like to run mediation analysis but my independent variable motivation (motivated: 1, control: 2) which has two levels. The predictor and dependent variables are continuous. Is...

24 April 2022 8,644 2 View

Is there any way conducting bootstrapping for repeated measueres ANOVA in SPPS?

Hi everyone, Is there any way to conduct bootstrapping for repeated measueres ANOVA in SPPS? (I am using versionn 25) I cannot see any bootstrapping option under for general linear model-repeated...

17 April 2022 7,350 3 View

How can I deal with non-normal data for mixed ANOVA?

Hi, I was planning to conduct mixed ANOVA for my analysis for my data since I have two within factors and one between subject factor variable. However, my data is not normally distributed and...

15 April 2022 6,994 3 View

How is the antenna bandwidth interpreted if the S11 graph cannot go above -10 dB?

I tried to design UWB antenna. I obtained S11 graph in below figure. The graph goes below -10 dB at 1.93 GHz but does not go above -10 dB at any frequencies. I ran the program for the 0.1-50GHz...

15 September 2021 6,804 0 View

How to estimate interrater-reliability of a variable with 3 columns of answer?

Hello everyone, In my study, I asked participants to write 3 different memories. After collecting data, 2 raters coded these memories. Now I have 3 columns for the first rater and 3 columns for...

06 February 2021 7,791 8 View

Why does my protein refolded to beta sheet during thermal denaturation analysis?

Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...

06 August 2024 1,989 3 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

CAD File of human's & rat's respiratory airways ?

Dear all, I am working on particle deposition in human's & rat's respiratory airways using CFD and I am looking for the 3D CAD file for my simulations (STEP or IGES format). If somone has such...

29 July 2024 1,092 2 View

Expansion thermal of muscle ?

What is the thermal expansion coefficient of human muscle?

27 July 2024 7,190 0 View

Problem with Two-phase simulation?

Hello; I am conducting a CFD study on two-phase flow in a separator, utilizing refrigerant as the working fluid. For this study, I have implemented pressure inlet and pressure outlet boundary...

25 July 2024 2,309 5 View

Flow through curved domains?

Hi everyone, I am working on a curved domain in which a ship is situated in the middle (geometry is given below). In my understanding the general fluid flow is parallel to the x axis from inlet to...

25 July 2024 9,058 4 View

Can anyone kindly suggest research topics in the area of thermodynamics, heat transfer, fluid mechanics or renewable energy?

I am an undergraduate mechanical engineering student seeking suggestions on topics related to either thermodynamics, fluid mechanics, heat transfer or renewable energy for my final year project....

24 July 2024 4,058 5 View

What are the most PROBLEMS of HYBRID nanofluid in oil industry ?

explain your idea

23 July 2024 1,197 0 View

Provided that the shale conductivity termed here x increases with temperature, how could we compute it at reservoir temperature ?

one could use Waxman and Thomas (1974) work?

22 July 2024 6,637 0 View

James Garry

Berkan,

Do you mean "Therminol" perhaps?

Berkan Koç

probably yes

Okay,

"Therminol" is a tradename for a range of fluids, that are based on diphenyl oxide and biphenyl (yum!).

The properties of various blends are listed here:

https://www.therminol.com/sites/therminol/files/documents/TF8691.pdf

And if the fraction of the nanoparticles is small, by mass, I'd simply ignore their contribution to the thermal conductivity value.

Beware the archaic units for k.