I have three solutions (glycerol, EGTA and LiCL) that were already autoclaved, and I intend to use those in ChIP experiment .. My question to you is does autoclave affect the ingredients of those mentioned buffers?
I appreciate your help
As much as I know glycerol is not affected by autoclave for the first time
To determine protein concentration of unknown samples (whole cells lysate) coming through the standard curve that has to be plotted before, I know that that can be obtained after multiplying the...
06 December 2020 3,767 3 View
I am going to extract proteins, and for that, I will use a protease inhibitor cocktail and Phospho-Stop (from Sigma). For protease inhibitor stock solution (2x conc.), it is mentioned through the...
26 October 2020 4,499 3 View
Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container
30 July 2024 7,326 1 View
Thanks
22 July 2024 1,143 3 View
DNA isolation requires many freshly made buffers. So is it necessary to autoclave each vessel used, before preparing buffers in them?
10 July 2024 7,526 3 View
Dear researchers, I've been working on aqueous plant extract sample, then I autoclaved them in 10 min to sterilize and added some preservatives. However, some of them showed bacterial and fungal...
11 June 2024 1,040 2 View
I'm currently studying the treatment of sewage wastewater and am interested in understanding the impact of autoclaving on the concentration of heavy metals. Specifically, I would like to know if...
10 June 2024 2,579 4 View
I understand that there are differences in ion preference as far as chelation is concerned when comparing EGTA vs EDTA. But is it ok to replace EGTA in my lysis buffer with EDTA since EDTA...
10 June 2024 1,188 1 View
The buffer wasn't filtered.. Could this be the cause? Can we autoclave phosphate buffer to resolve this issue?
10 June 2024 3,970 2 View
I am using CTAB method (Naser M. Salameh et al., 2014) for fungal DNA isolation and purification. During reagents preparation I am not sure weather I should autoclave 2X CTAB and Wash buffer. So...
09 June 2024 8,470 2 View
I used Vero E6 cells and Mayaro virus. The virus was diluted in DMEM without FBS. The plaque media was 2X MEM, prepared with sodium bicarbonate and L-glutamine, adjusted to a pH of 4 with sodium...
03 June 2024 519 0 View
the autoclave has been smelly and seem likely yellow after my synthesis and this changes may effected on other synthesis, so I want to clean PTFE from all sulfur contamination that remain on...
31 May 2024 2,985 0 View