What degree of missing data in a particular case/participant results in Expectation-Maximisation no longer working?

I'm dealing with a mediation model and am using the PROCESS module in SPSS. Due to SPSS and PROCESS being limited in the imputation methods - being unable to handle multiple imputation - the other...

02 March 2021 4,362 1 View

Has anyone succeeded in capturing uranium atoms in a fullerene structure?

Additional questions are: What are the encapsulating atoms? How difficult was the process and what rates were achieved? What factors most seriously affect the economics?

20 February 2021 3,134 5 View

How to phrase semi-structured interview questions using IPA without biasing superordinate themes?

Hello, I am preparing a semi-structured interview schedule for an interpretative phenomenological analysis study on marginalized individuals' career experiences as impacted by COVID-19. The aim...

19 February 2021 9,099 2 View

No title

19 January 2021 6,848 4 View

Why do my fibroblasts under hypoxia conditions proliferate slower than the same fibroblasts under normoxic conditions?

I am using healthy control lung fibroblasts in a 96 hour experiment with two drugs (nintedanib and Pirfenidone) and vehicle controls for both. I have both hypoxia (approx 1% O2) and normoxia...

12 January 2021 6,260 1 View

How much does radiative heat transfer effect thermal conductivity of materials and how to compare calculations to experirment?

I am calculating the phonon contribution to thermal conductivity for 4 perovskites (BaZrO3, BaSnO3, BaHfO3, and KTaO3) with relatively wide bandgap. When I compare my results for BaZrO3 to the...

27 December 2020 3,232 3 View

Proper method for assessing model invariance following Confirmatory Factor Analysis (CFA) and preceding 2x2 between-subject analysis?

I have produced a good-fitting, reliable baseline model according to CFA. The model contains several factors each loaded by several categorical (ordinal) items. I ultimately intend to analyze the...

15 December 2020 1,668 4 View

How to Reinstall Operating System for a TA Instruments 2910 DSC?

Hard drive crashed on an old windows 2000 that was used to control a TA Instruments 2910 DSC. Installed new hard drive and I am trying to figure out where I can find the software/operating system...

17 November 2020 2,467 3 View

Communities based websites do they serve a purpose?

I'm asking and posing this question as it forms a part of my final project year. I building an ASP.net community-based website coupled with an Oracle database and I'm looking for feedback,...

17 November 2020 7,852 1 View

How can I solve Error: "The coupling service failed to start" during simulation ANSYS 2Way FSI?

Hello, I am dealing with error during lounching 2 Way FSI in ANSYS Workbench. Setup of the Fluent is ok (stand alone I am receiving expected results) and FEM uses Transient Structural. Once I run...

11 November 2020 3,816 4 View

What is Flat Lens Antenna?

28 February 2021 5,433 3 View

Can impedance of antenna be less than 50 ohms?

I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...

27 February 2021 4,218 7 View

How to measure angle between laser travel path and machine axis in Laser Measurement system?

25 February 2021 1,987 3 View

Helix antenna coupling problem?

Dealing with a helix antenna, made with flexible material and not rigid like using a PCB board or wire. At the beginning of the helix is too close to the ground plane, causing coupling. How can I...

21 February 2021 4,453 3 View

How to get better phase shift in C-V curves for ferroelectric devices?

I tried to sweep my ferroelectric devices from -2V to 2V and then from 2V to -2V and The two hysteresis peaks are off by several microFarads. Should i increase bias voltage? I am doing these...

16 February 2021 8,514 2 View

Design parameters of L1 frequency Helix antenna?

Could I please get the guidance on Helix antenna operated from 1.5 - 1.8 GHz. I am designing in hfss and not able to cover 1.5 GHz. Could I get papers or suggestions on numbers I use to cover this...

02 February 2021 622 7 View

Statistical methods for comparing gene expression curves?

Hi all, I have generated two gene expression curves by measuring bioluminescence every 10 mins for 12 hrs. These curves tend to overlap at at some time points, while a difference can be seen at...

02 February 2021 2,613 7 View

Should I make 2 helical antennas? One for 2.4 GHz and another for 5.8 GHz?

Should I make 2 antennas, one for 2.4 GHz and one for 5.8 GHz? How should I approach the problem if I want to design the antennas which cover 400 and 900 MHz and 2.4 and 5.8 GHz? All together in...

26 January 2021 906 3 View

VSWR is shooting to 2.1 or even 2.3 in UHF dipole antenna, why?

So, I have a design, two dipoles working at UHF and VHF. We fed using a diplexer. I am having difficulties with the testing using network analyzer. VHF passes but UHF, specially at 400 MHZ, the...

26 January 2021 8,743 8 View

Can I simulate Ferrite in HFSS?

I have a design with 2 dipoles working at different frequencies joined in one system and separated by Ferrite. I think, Ferrite was used to minimize the interference between 2 antennas as much as...

25 January 2021 5,918 3 View