Terminal sliding mode of power term?

Yufei Laing @Yufei-Laing

07 May 2022 0 8K Report

How does Simulink express the fractional power term of terminal sliding mode

Badges
Science topic

More Yufei Laing's questions See All

How to purify Schiff base product?

How to stabilise the Schiff base product and avoid it from reverse back to the aldehyde and primary amine.

09 June 2024 9,264 5 View

Which HA beads are the best for Co-IP (drosophila tissue)?

Hi all, I am using HA beads to do a Co-IP (using drosophila whole body), then do mass spec to detect the interacting partners that pulled down by HA. The one that I tried before was not good, it...

09 April 2024 2,374 0 View

How to dissolve lyophilized silk fibroin?

I have prepared silk fibroin from cocoons following the protocol established by the Kaplan group. However, in their protocol, they specified that "silk fibroin can be frozen under -80 or -20...

13 September 2023 902 0 View

Is there ant fluorescent protein with a totally different structure than GFP?

GFP and most other FPs have 11 beta-strands, and make up the beta-barrel. Is there any FP with a totally different structure?

08 July 2023 3,228 3 View

How can I modify the spaceshift and phaseshift of specific antenna array using the "array factor" in farfield options?

Dears, I am working on array analysis recently, but when trying to simulate arrays with specific distribution of phase and amplitude, the "array factor" module seems not handy. I wish to take...

01 July 2023 7,683 2 View

Is the coupling of stretching-bending included in the Foppl-van Karman equation for two-dimension?

I am not familiar with the Foppl-van Karman equation describing the large deflections of flat plates, where stretching is induced by bending in three-dimension, but not in two-dimension. I want to...

30 August 2022 2,817 0 View

What would the economy look like if the Upper Peninsula left Michigan?

I am currently working on an exhibit on the truth behind the Upper Peninsula(U.P.) gaining its own statehood. I have found information on taxes from each county in the U.P. but I am looking for...

19 May 2019 525 4 View

Is it possible to trigger the ER stress while suppress the austophagy in tumor cells?

I‘m studying a natural product's anti-tumor effect on melanoma. I was noticing it triggered ER stress, but at the same time, the autophagy related protein such as ATG5, ATG12 were down...

10 September 2017 7,072 9 View

Is B16F10 a good model for studying the EMT(epithelial-mesenchymal transition) ?

I'm going to use the B16F10 as a EMT model for my drug's anti-tumor study. However, rare information has been found on Internet for the EMT induction of B16F10. I wonder what's the best way to...

27 November 2016 9,249 3 View

What is the difference between sensitivity and linearity when we evaluate the performance of an instrument?

I made a dilution series of a mixure of different compounds and significant correlations (R2 > 0.99) between the response of the compounds and corresponding concentrations were observed. Does...

12 February 2016 9,952 3 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

Help on understanding the implementation of Mori Tanaka method on MATLAB?

I am new to Micromechanics and having similar problem with understanding the implementation of the formula's. I would appreciate if anyone can guide me on how to go about getting a scalar value...

30 July 2024 969 0 View

How to simulate a varying three-phase load /load profile in Simulink/MATLAB?

I have a Simulink model that connected a main utility (AC-grid) with a three-phase load changing from 20kW to 100kW in 5 seconds and I don't know how to build this load in Simulink. Please your...

14 July 2024 8,892 3 View

Can we detect DOC fractions through LC-OCD for a sample containing Sodium Azide?

I did some column tests in my lab where I needed to detect the DOC fractions using LC-OCD. For the abiotic columns I used sodium azide to restrict the biofilm formation. I did LC-OCD to detect the...

07 July 2024 468 0 View

Dear Professor/Researcher, I want to use LoRa to send a signal with a frequency of 10 kHz. Is this feasible or not?

I use LoRa with Matlab/Simulink

23 June 2024 3,847 3 View

Aspen Adsorption linking to MATLab ??

Hi, I am looking to link MATLAB to Aspen Adsorption. I know that for Aspen Plus, it is possible to use actxserver(). Does anyone know if the same method can be used for Aspen Adsorption as well?...

20 June 2024 8,338 2 View

Which imaging and/or quantification techniques are best suited for identifying the multiple oxides in a thermally grown oxide scale?

Apart from XRD analysis, I want to know the other techniques used for identifying the oxide phases (even when a particular oxide is having very less volume fraction) present in a thermally grown...

14 June 2024 3,555 5 View

Is there way to remove apolar residue from glass in order to perform IR-MS?

I used a two-phase extraction protocol (essentially the Bligh-Dyer or Folch protocol) to fractionate C. elegans into aqueous metabolites, lipids, and protein. These worms have been fed bacteria...

11 June 2024 8,991 1 View

Replacement needle for brandel gradient fractionator?

Anyone know of a good replacement for the needle used to puncture gradient tubes on the brandel gradient fractionator? We use this system to fractionate sucrose gradients for polysome profiling,...

06 June 2024 8,323 0 View

Does anyone know where this module is in Simulink?

I try to build a three-phase wireless power transmission model and saw this module in an article.

27 May 2024 3,471 2 View