Greetings! I have provided inputs for SWASH, but unfortunately some errors occurred after running the program. Can you advise me on how to resolve these issues? Just to clarify, my bathymetry data does not contain any negative values and My grids are rectangular.
the error was:
0.482E+00 m/s
** Error : nonzero relative vertical velocity at surface in (m,n)=( 1, 152); omega = 0.375E+00 m/s
** Error : nonzero relative vertical velocity at surface in (m,n)=( 1, 153); omega = 0.236E+00 m/s
** Error : nonzero relative vertical velocity at surface in (m,n)=( 1, 154); omega = 0.771E-01 m/s
** Warning : water depth is negative in (m,n)=( 1, 166); water depth = -4.27 mm
** Warning : water depth is negative in (m,n)=( 1, 167); water depth = -8.84 mm
** Warning : water depth is negative in (m,n)=( 1, 168); water depth = -12.65 mm
** Warning : water depth is negative in (m,n)=( 1, 169); water depth = -15.36 mm
** Warning : water depth is negative in (m,n)=( 1, 170); water depth = -16.74 mm
** Warning : new minimal depth for checking drying and flooding: DEPMIN = 0.1691E-01
** Terminating error: INSTABLE: water level is too far below the bottom level!
** Message : Please reduce the time step!
Hello Ali,
I am having the same problem, did you find any solution for this?
Regards
- Badges
- Science topic
- Similar topics
- Phytochemistry
- Extracts