I was working on thermogravimetric analysis for some materials, however, because of the pandmy I stoped using the STA TG DTA-DSC 1600 for like 6 months, when I was able to work again with it, the temperature measurement system seems not to be working, now when I connect the software with the analyzer the frunance sensor marks 1740°C all the time, even without heating and the external sensor marks 0°C. Can somebody tell me what the problem might be or any sugestion on how solving it?
Thanks in advance.
BTW: The software I'm using is Calisto v. 1.36.
If the display for temperature appears to be wrong then it can be the fault of the electronic temperature measurement unit or defective sensor. One can check the sensor, if it is broken.
Snehadri Bihari Ota thanks for your answer, I checked the sensors today and they showed to be fine, is there a way I can identify where the electronic problem is?, I mean like a way to make a diagnosis either manual or with the Calisto software.
Thanks in advance!
- Badges
- Science topic
- Similar topics
- Methodology
- Sensors