What is latent heat of ethanol at 30 degree celcius?

i want to know the latent heat of ethanol at 30 degree temperature and also the saturation temperature of ethanol corresponding to saturation pressure

04 May 2019 7,141 1 View

Simulating two phase heat and mass transfer inside two phase closed thermosyphon.contour showing phase change only in the evaporator region.Why?

10 November 2018 8,576 4 View

How much latent heat can be rejected by condenser?

on what factors the capacity of condenser depends?

04 May 2018 6,660 0 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

No title

02 March 2021 932 1 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

APA 7th In-Text citations with two references with three authors with the same surname, but four different author?

I have an issue with APA 7th in-text citation. II have two papers where the first three authors are the same, and the fourth is different. I am using the Mendeley desktop app, and automatically it...

02 March 2021 790 3 View

Where can I find life cycle inventory or assessment of non woven materials?

Dear network, I am looking for the LCA or LCI or at least the energy balances of the non woven fabrics process for my master project, in specific for natural fibers, yet I have found...

02 March 2021 9,662 1 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

How Download/Extract citations of 1 given year ALL my publications in Google Scholar?

If you google this you find a lot of smart guys explaining you how to download 1 year of citations of 1 single paper of yours (or anyone else). I mean 1 year of ALL my papers. or ... ALL years or...

01 March 2021 1,121 9 View

How can I edit suggested publications?

Hi there! I regularly receive suggestion about papers and authors that are totally out of my area. Does anybody know how I can fix this? Thank you!

01 March 2021 9,574 4 View

How to show arrows over the streamlines in CFD-post?

I follow this to make streamlines like the photos attached below: (software- CFD post-processing) First I plot the 2D streamline over a surface "streamline 1". them I plot a vector by the...

01 March 2021 8,668 3 View

Which one is easier and better at modeling slender masonry structures? ANSYS or ABAQUS?

I need to model masonry and reinforced concrete minarets for my MSc thesis. Which one is easier and better at modeling slender masonry structures? ANSYS or ABAQUS? (Or any other program for just...

01 March 2021 736 3 View