How to recycle Sodium Iodide?

Hi, I am using sodium iodide to separate density carbon fractions of my samples. I want to recyle it for further uses. While searching I only get the process to recycle sodium polytungstate (at...

20 September 2020 9,556 2 View

How does the pH of the solution affects the dispersion behavior of large sized graphene oxide nanosheets in various solvents?

I am trying to understand the dispersion behavior of graphene oxide in a range of organic and inorganic solvents to understand their specific applicability. Thus the pH dependent solubility...

26 August 2020 4,907 4 View

How to take PL of Methylammonium Lead iodide thin film?

I am working on methylammonium lead iodide perovskite thin films. Whenever I try to take PL of MAPbI3 thin films using Agilent Cary Eclipse Fluorescence Spectrophotometer I didn't get any peak....

11 April 2019 5,176 4 View

I am trying to subculture my isolated yeast strain from it's mother culture YPD medium plate. But its not growing at all. How to subculture it again?

I have tried with different media. But its not showing any result. Yeast strain Medium used: Yeast extract Peptone Dextrose Agar, Sabouraud Dextrose agar, Yeast extract Peptone Sucrose Agar.

06 December 2018 3,032 1 View

How can I effectively culture pesticide resistant soil bacteria ? Should I include soil extract or use only nutrient agar ?

I am looking for recommendations to effectively culture pesticide resistant bacteria. I tried with normal LB agar without pesticides and results are not satisfying as only one particular...

01 November 2018 217 6 View

Which is the most efficient glass surface cleaning protocol?

I want to clean the glass surfaces for surface modification analysis, therefore i am exploring various glass cleaning protocols for the maximum possible decontamination. ( Organic, inorganic and...

29 August 2018 4,982 4 View

How can UV-Vis spectroscopy be used to calculate lateral dimension of 2D nanosheets?

I am trying to calculate the lateral dimensions of prepared graphene oxide nano-sheets dispersed in water, several articles have indicated that UV Vis can be used as a tool to do so . However, i...

19 February 2018 5,468 3 View

How the polydispersity of graphene oxide nanosheets synthesized by hummer's process can be minimized ?

I am preparing the GO nanosheets using Hummer's process, but synthesized nanosheets are of very high polydispersity in terms of lateral dimensions. Is there any method by which the polydispersity...

17 December 2017 7,229 3 View

Is it possible to segregate graphene oxide nanosheets from a solution on the basis of their lateral dimensions?

I have an aqueous solution of exfoliated graphene oxide ( by ultrasonication) , Now if i wish to segregate these nanosheets on the basis of their lateral dimesions, how can i do so.?

30 October 2017 7,789 3 View

Can AUVs compute Angle of Arrival of incoming signal in UWSN?

Are the Autonomous Underwater Vehicles (AUVs) capable of finding Angle of Arrival of an incoming signal?

12 May 2016 6,958 3 View

How to analyze a particular region of my simulation box in GROMACS?

Hi, I am using GROMACS 5.1.4 to simulate water in contact with a surface. I am only interested to calculate some properties of water near the surface. Let's say at a distance of x nm from the...

03 March 2021 9,989 2 View

How to get onecolumn document from standard IEEE ACCESS LateX template?

I have prepared a manuscript in IEEE Latex template, but for some purpose, I need to prepare a word file as well (detailed format is not required). Compared to two column .tex file, one column...

02 March 2021 1,830 3 View

How can the modification of garden soil cause global warming?

Hello, I am working on a soil project and I found a primary research article that tests how the modification of agricultural soil can cause global warming, using a thermal collector, however I...

02 March 2021 7,161 3 View

Does anyone know how to plot my station to a section plot on Ocean Data View (ODV)?

I made a vertical section plot with WOA .nc file on ODV, and now I want to plot my stations (csv. file) in it. Does anyone know how to import my points to the section? They are two different...

01 March 2021 3,610 1 View

Does anyone know to clarify these changes?

01 March 2021 1,290 2 View

How can I convert .vesta file to a .cif file?

I've used the "export data" option in Vesta software to convert my unit cell into a cif file however when I use that cif in atomsk it shows error such as "can't read the position of atom 0". If I...

28 February 2021 4,966 3 View

How to find the right number of integration points in second order 3d finite elements?

I am familiar with finite element simulations and numerical schemes like the Gauss Legendre quadrature. I also know that the Gauss integration yields exact values for polynomials up to degree 2n-1...

27 February 2021 6,818 3 View

How can we use a hybrid element in Abaqus Dynamic/Explicit for impressible materials?

Hi, all! How can we use a hybrid element in Abaqus Dynamic/Explicit for impressible materials? I have not find the choice for explicit element in Abaqus CAE. I am wondering whether it is possible...

25 February 2021 9,936 2 View

No title

25 February 2021 5,713 1 View

Anyone that can help with Maxquant TMT16plex which is missing?

Hi I am very new to proteomics analysis. I have got raw files from core facility running thermofisher TMT 16plex 4 hours. I cannot find on maxquant the option TMT16Plex there is only up to 11...

25 February 2021 1,675 3 View