LDPC decoders
10 November 2015 6,767 3 View
Digital signal processing implementation
10 November 2015 7,148 1 View
09 October 2015 9,498 1 View
assume that the decoding complexity is not an issue.
09 October 2015 2,837 1 View
cooperative coding and network coding
09 October 2015 5,336 0 View
assume that the decoding complexity is not an issue
09 October 2015 9,058 2 View
without calculating the matrix G.
08 September 2015 678 5 View
permutation codes are good for criss-cross error correction
08 September 2015 8,133 0 View
Are the frames over the physical layer processed completely independently?
08 September 2015 6,145 1 View
LPDC codes
08 September 2015 1,284 1 View
Hello all, In SPSS I am going to code 2 open-ended questions. I have already read all the answers and I made a list of the most important categories to which I can code the answers. This question...
02 March 2021 1,757 4 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
I am a master student and i am working on my research, so I am a bit confuse don't really know how to match computer with telecommunication as a topic
28 February 2021 7,039 6 View
The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...
28 February 2021 6,560 14 View
28 February 2021 5,433 3 View
I am working on modeling and simulation of biomecanical material behaviour, I have succeded on simulating skin using anisotropic hyperelastic material, on APDL and in our lab's finite element...
28 February 2021 552 3 View
I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...
27 February 2021 4,218 7 View
for all the rheology researchers, my question is, how relevant is a mini slump cone (smaller than a standard 50 cent rheometer). currently based on testing, the thickness of slumped material is...
26 February 2021 3,668 1 View
I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...
25 February 2021 2,615 3 View
Hello, As part of simulation of gases mixture and water, I need to calculate viscosity of the fluid components and I am using relationships proposed by Chung et al. (1988). The irony is while I...
25 February 2021 8,053 5 View