What is the reason for mismatch/frequency shift between measured and simulated results at high frequencies apart from insertion losses of the connectors, fabrication tolerances, reflections (mismatched load), higher order modes etc?
Is it because of the change in the real and imaginary part of permittivity at high frequencies?
Picture Source: https://en.wikipedia.org/wiki/Permittivity
Both of their units are A/m, yet both seem to be different! What is the difference?
05 June 2019 2,902 7 View
Hi, How many mL of FeCl3.H2O solution is required to just dissolve 1 g of copper in 1 hour? Please provide the chemical and mathematical equations too! With Regards, Suhas D.
09 October 2018 1,214 7 View
The practical magnitude of axial ratio for circular polarization can go upto 6 dB (0 dB
06 July 2018 2,697 11 View
The finite conductivity of the conductor is one source. Other is, if the junctions are mismatched. What could be the other sources? Hmmm...?
03 April 2018 8,083 3 View
What are the antenna parameters required for 4G LTE advanced technology? Please explain in detail! 1. No. of Antennas (I believe it is 8*8 or 8*4). But why? 2. Radiation Pattern? 3. Beamwidth? 4....
11 December 2017 1,659 3 View
How much antenna bandwidth do I need to transmit 100 Mbps (4G) or let's say 1 Gbps (4G LTE) of data? What is the relationship between Hertz (cycles/second) and bits per second? Or, how many...
11 December 2017 1,983 6 View
What is the physical significance of Half Power Beam Width and First Null Beam Width of an antenna?
10 November 2017 5,569 5 View
I understand that vectors are a subset of Tensors. Can someone please define tensors in a simple manner? I read about tensors from quora and saw some videos too, but still couldn't grasp its inner...
04 May 2017 494 4 View
Was Hertz’s findings and contributions not significantly influenced by theFitzGerald, Lodge, and Heaviside (The Maxwellian's)?
03 April 2017 557 8 View
Is it Stress alone, the food we eat?
02 March 2017 9,092 2 View
I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...
10 August 2024 3,629 1 View
We have observed that tube to tube sheet joint leaked in our boiler and needs to overcome same by knowing the root cause.
08 August 2024 3,161 0 View
All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.
01 August 2024 589 4 View
I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...
01 August 2024 2,614 1 View
Hey All! I am wondering what might be wrong with my band structure. I did the calculations using VASP and plotted the results using Origin. Although I have tried changing various input...
25 July 2024 2,920 11 View
It is being seen that Editors of some reputed Journals are putting on hold the manuscripts and not updating review states even passing more than six months from submission. Researchers are...
24 July 2024 8,596 2 View
I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...
16 July 2024 5,031 1 View
Our lab has some radioactive cell samples that need to be kept frozen for at least 30 days before flow analysis. For some reason, the samples stored in liquid nitrogen did not perform as well as...
15 July 2024 9,975 1 View
I performed CV of Cu-MOF in a buffer solution of pH 8, and we did not find any peak corresponding to Cu2+ to Cu+. What is the reason behind this? Please give your valuable suggestions.
08 July 2024 2,388 4 View
What could be the reason for mixotrophs to be yellow too instead of green? Thank you
08 July 2024 594 2 View