I have the block diagram of the PEM FUEL CELL ENHANCED POWER SYSTEM.I need fmiliarisation with the matlab environment.First of all the electrical model of the fuel cell with the three type of fuel cell resistance have to be considered,then with fuel stack current , an inverter, a diode to stop the current from reversing.Then coverting to the control system equations and blocks.The input parameters will have to be considered.I have some publications already today on that but finding it a bit hard to digest will read more and give more time.Then the current should have an output of 10kw.so stacking of the fuel cell will be mandatory and if possible a boiler and steam turbine and ac generator.

since fuel cell installation is expensive i will need grant platforms where i can get some money for it by God's grace.Please if you collaborate you will be a co-author in publications.I have a diagram a block diagram of the system and i am reading up on some aspects for matlab simulink environment.kindly assist if you can.

Thanks God bless

igwilo ossy c