How to analyze a particular region of my simulation box in GROMACS?

Hi, I am using GROMACS 5.1.4 to simulate water in contact with a surface. I am only interested to calculate some properties of water near the surface. Let's say at a distance of x nm from the...

03 March 2021 9,989 2 View

Why the results when using wall thickness and when using shell conduction are different in ansys fluent?

Actually, I am running cfd simulation for a heat exchanger which has two fluids one hot and other one is cold fluid. there is a solid domain between them, which I removed and instead I have used...

01 March 2021 9,537 2 View

How much pressure we can reduce at the outlet to avoid Reverse Flow?

I am simulating Heat Exchanger. I have tried and tested all the methods to resolve this issue from the internet like refining mesh, improving skewness and orthogonal quality ,extending outlet to...

01 March 2021 6,985 3 View

Could you please recommend some good journal that accept very long revie papers (approximately 6000+ words) in neurosurgery, cancer biology ?

Could you please recommend some good journal that accept very long revie papers (approximately 6000+ words) in neurosurgery, cancer biology ?

01 March 2021 8,087 3 View

Does anyone know to clarify these changes?

01 March 2021 1,290 2 View

What is recommended for solid domain in ANSYS FLUENT?

Should I mesh the solid domain ? or should I use wall thickness? or Shell conduction? for Heat Transfer between two fluids of a Heat Exchanger. what is recommended?

01 March 2021 9,785 3 View

Can Virtual Servers (remote dekstop manager) run heavy ANSYS Fluent CFD simulation ?

I have a virtual machine. My host Pc specs are not that good thats why i went for virtual servers. so basically my host pc has 8gb of ram with nvidia quadro k2200 4Gb DDR5 GPU ,processor intel...

01 March 2021 8,415 1 View

Can the Dunn's test be used as an appropriate post-hoc for the G-test?

Research Question: Are red grouse (Lagopus lagopus scotica) a statistically significant proportion of raptor (bird of prey) diets? I am planning on using a series of G-tests (determining whether...

23 February 2021 5,827 3 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Where can the fault diagnosis data set of lithium battery be found?

Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...

21 February 2021 8,659 1 View

Does anyone know an alternative product for cardiac Troponin T antibody for Immunofluorescence (Thermo # MA512960)?

We have been using Thermo Fisher anti-cardiac Troponin T antibody for immunofluorescence staining in FFPE mouse heart sections but it was recently discontinued. The literature shows it to be the...

01 March 2021 4,937 1 View

Hello .Ineed a researchs about systolic heart failure any one can help me ?

Am a master student .I need an information about this case to write my thesis?

09 February 2021 9,706 2 View

Does euthanasia by CO2 inhalation cause NF-kB activation in mouse heart or body in general?

I was wondering if euthanizing mice by carbon dioxide inhalation would cause activation of NF-kB inflammatory response?

26 January 2021 4,096 2 View

Is there any method I can use to isolate single cells (i.e cardiomyocytes and non-cardiomyocytes) from snap from rat heart tissue?

I have GD18.5 heart tissue currently snap frozen in -80, apart from mRNA and protein analysis on whole tissue, is there a way of isolating single cell populations to study localization of a...

19 January 2021 4,044 3 View

Are COVID 19 vaccines reliable for people with medical conditions, like those with respiratory issues, diabetes, heart problems, etc.?

Are COVID 19 vaccines reliable for people with medical conditions, like those with respiratory issues, diabetes, heart problems, etc.?

22 December 2020 5,948 7 View

Help determining the most important covariable?

Hello everyone, I'm rather new to data science as a whole and I've come accross this issue. I have a dataset in which patients are granted a score based on certain variables (blood pressure,...

16 December 2020 9,361 3 View

What part of heart ?

Hello You can see a transversal slice of a mouse heart in microscopie with blue coloration. My question : what part of the heart is it ? how i can recognize difference between histology of...

01 December 2020 1,000 3 View

Anyone with experience conducting proximity ligation assay (PLA) in mouse heart tissue ?

I was wondering if anyone had any experience doing proximity ligation assays (PLA) using mouse whole heart (ventricular) tissue (in any state)?

29 November 2020 9,103 1 View

Using Circwave or JTK_cycle for qPCR data?

Hello everyone, My experiment is to assess the expression levels in cultured cells after the clock has been reset, or in mouse liver by qPCR. I have multiple timepoints and have performed...

21 November 2020 802 2 View

Output from ANFIS for heart disease classification is real number not the desired classes?

I am trying to train ANFIS on heart disease dataset (extracted from UCI repository). I used MATLAB. after training when I get the results, they aren't the desired classes, which are [0,1] 0 for...

15 November 2020 266 5 View