Hello,

I am doing some research work on the parallel connection of the bidirectional buck boost converter. I will upload the schematic at the end.

Using the converters, I charge and discharge different chemistry of batteries. During charging phase, the converter works as a buck to charge the battery. During discharging phase, the converter works as a boost converter to give supply to the loads connected to the load bus.

Generally, if it is single converter we use voltage controlled mode but I am connecting them in parallel I need control methods like droop or current control methods.

I searched many for many journals about it. But could not find much information. I want some circuits as well.

Can someone please help me.

Similar questions and discussions