Does the circuit modeling for planar monopole antennas using Foster canonical forms give good approximation?

Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...

28 February 2021 7,016 1 View

Helix antenna coupling problem?

Dealing with a helix antenna, made with flexible material and not rigid like using a PCB board or wire. At the beginning of the helix is too close to the ground plane, causing coupling. How can I...

21 February 2021 4,453 3 View

How to make a site-Selective Electroless Nickel Plating?

I would like to plating Ni/Au on the selected area. Can anyone give me a suggestion? It is a bit like to make golden finger on PCB board. Instead with the PCB board, I use polyimide as my...

28 January 2021 8,330 1 View

Can you tell the pros and cons of the proposed active AC coupling circuit?

Are there analog circuit designers? Here is a small task for you. The active circuit below aims to improve the AC coupling in the biosignal amplifiers. Is that so? Are there any pros? I'm...

17 January 2021 3,548 14 View

How to simulate correct plasma effects in circuit breaker?

03 January 2021 5,869 2 View

Which is the best quantum circuit simulator for quantum image processing techniques?

Dear all, Kindly let me know the best quantum circuit simulator to apply quantum image processing techniques like image filters, edge detection, etc. thanks and regards

21 December 2020 7,991 1 View

Why isn't UV Laser based PCB manufacturing more mainstream yet?

While feeling the shared pain of costly and slow PCB Manufacturing process. Which also makes the hardware creativity and education much costly and slow. I was trying to figure out how can we...

14 December 2020 1,484 1 View

Is it possible and practical to build an electronic box with this transfer function?

PID controller is reportedly widely built and used in control systems engineering for industrial applications. The PID-controller has a transfer function as: (Kd*s^2+Kp*s+Ki)/s. Therefore, it...

08 November 2020 7,771 10 View

How can i increase the power of the ultrasonic pizeoelcetric sensor to atomize a viscous liquid?

I use a piezoelectric sensor, a humidifier electronic circuit and a 32-volt power supply to generate high-frequency ultrasound waves. I use these waves to atomize the liquid. the problem is that...

16 October 2020 5,097 8 View

How to deal with ANSYS Q3D surface mesh generation error?

I am trying to extract the stray inductance of a PCB bus bar using ANSYS Q3D. I tried different types of meshes but every time in the middle of the simulation, this error "Surface Mesh Generation...

10 September 2020 2,060 3 View