I've input a multi-layer wells shapefile into a FEFLOW model and the wells are associated with the rightful Slices, on the right locations and one per mesh element. I also made the linkage (in the multilayer-wells input menu) between the wells and their pumping rates but when I run the inspection they show NO PUMPING RATES! Has anyone a idea of what might have gone wrong or how to correctly input multi-layer wells shapefiles? I can't find a clue to this problem in the User's Manual. Please HELP! 📷
And no, I didn't forget the Snap distance: snap distance was set = 0 m
Maria emilia Novo Did u tried assigning by manually edge selection at that point?
add some image to understand the situation
well, yes I assigned the edge selection and the problem was not at one point but with all wells. I assigned the edge selection to the whole model domain once the wells were scattered throughout the model. What happened, is that apparently the wells are input, the model run with their the respective pumping rates but it does not show any info about the wells when I use the Inspector to verify those well data.
Besides, in this new model, I am doing exactly the same procedure I did before but now the model misplaces all wells, deleting several ones and overlapping all others onto hydraulic head BCs. And yes, I did snap distance = 0
- Badges
- Science topic
- Similar topics
- Engineering
- Modeling