Mr. Musil, do you have an article that talks about the temperature, and the pressure of deposition?

Why do i have a weak plasma and no coating during rf sputtering?

I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.

07 August 2024 4,526 4 View

How to assess the osmotic power of a substance?

Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...

06 August 2024 977 1 View

Please introduce me the latest published articles on the structure and properties of metal nanocomposites?

26 July 2024 2,200 3 View

Optimal condition for depositing FTO target 95:5% using sputter technique?

Hello I want to know about the sputtering condition of depositing FTO from target 95:5%. I tried with RF sputter in pressure 2.5Pa and 100 sccm Ar at room temperature but it showing no...

21 July 2024 1,680 2 View

What could be the possible reason that sintering of polycrystalline diamond fabricated with tape casting has suddenly started failing?

I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...

16 July 2024 3,212 5 View

The HCP removal rate is lower than usual in concentration step, why?

Hello everyone. I am working on my LV concentration porject, I use 500Kda hollowfiber to do it. The HCP and BSA removal rate is nearly 80%, but last time, I failed to run it. The HCP hasn't been...

11 July 2024 5,380 0 View

After regeneration studies of the PVDF membrane, will the permeate flux and TDS removal efficiency increase or decrease?

Regeneration Studies for the PVDF membrane and PVDF/CuO nanocomposite membrane were carried out by chemical cleaning.

07 July 2024 7,033 0 View

Pressure in Iron Iron Carbide?

What will be the pressure in Iron Iron-Carbide diagram? It is at atmospheric pressure?

05 July 2024 1,891 0 View

What does the disappearance of the XRD peak near 8 degrees, corresponding to the (002) plane of MXene, imply in a MXene-based nanocomposite?

I am trying to synthesize Mxene based nanocomposites. Interestingly, the characteritic peak dissapears which indicates the disruption in interlayer spacing of MXene. So, what might be other...

03 July 2024 5,702 3 View

How to Perform Randall-Selitto Test (Paw Pressure Test) In Mice?

Hi All, My name is Sumaiya, a PhD student at the University of Queensland. I am looking for some suggestions on how to hold mice and perform Randall-Selitto Test by using Paw Pressure Randall...

30 June 2024 6,004 0 View

Jindrich Musil

Dear colleague,

Please let me know your e-mail address to start a private communication in this matter.

Kind regards,

Prof. Jindrich Musil, D.Sc.

Department of Physics, Faculty of Applied Sciences

University of West Bohemia

Univerzitni 22, CZ - 306 14 Plzen

Czech Republic

E-mail: [email protected]

November 22, 2018

Frederico Cuba

Thanks Mr. mine email is [email protected]