May i know the quantity of ethanol needed for surface modification of caco3?

More Ashifat Olawumi's questions See All

Request for Response to a Survey?

Dear Sir/Madam, Hope you are doing well. I need your help on a questionnaire survey related to BIM & Sustainable practices in the Construction Industry that I'm conducting. You can either make...

04 October 2017 7,747 6 View

What is the effect of PEDOT:PSS on the environment?

i want to know if PEDOT has good effect on our environment.

08 April 2016 5,950 1 View

Effect of pressure on flow rate of polyester?

oscillatory rheology of polyester

27 March 2016 7,199 4 View

Which is the best way to get rid of copper residue on the back side of wafers following plating even after bevel edge clean and backside clean?

Following electroplating of Cu, residues of Cu are seen on the backside of the wafer. Bevel edge clean and backside clean seem to make it worse. Probably increases the roughness of the backside...

20 February 2015 8,890 3 View

What could be responsible for arcing during via etch in a vacuum chamber?

During BEoL via patterning, arcing is observed sometimes to the point of wafer breakage(seal band arcing). Failure analyses show craters at the point of the arcing. These craters appear at other...

11 February 2015 3,304 12 View

..choosing optimal lag for a model is an empirical issue! What is your opinion?

Although decision on this can be guided by the rule-of-thumb that says you choose the model that gives the lowest values among the criteria (i.e. Akaike, Schwarz, etc).

01 January 1970 3,199 1 View

𝐵𝑙𝑜𝑐𝑘𝑐ℎ𝑎𝑖𝑛 𝑉𝑎𝑙𝑢𝑒 𝑀𝑜𝑑𝑒𝑙 (𝐵𝑉𝑀) 𝑓𝑜𝑟 𝐶𝑜𝑛𝑠𝑡𝑟𝑢𝑐𝑡𝑖𝑜𝑛 𝑆𝑢𝑝𝑝𝑙𝑦 𝐶ℎ𝑎𝑖𝑛: Survey invitation

We are conducting a research project on "𝐵𝑙𝑜𝑐𝑘𝑐ℎ𝑎𝑖𝑛 𝑉𝑎𝑙𝑢𝑒 𝑀𝑜𝑑𝑒𝑙 (𝐵𝑉𝑀) 𝑓𝑜𝑟 𝐶𝑜𝑛𝑠𝑡𝑟𝑢𝑐𝑡𝑖𝑜𝑛 𝑆𝑢𝑝𝑝𝑙𝑦 𝐶ℎ𝑎𝑖𝑛" and currently seeking to leverage your knowledge and experience 𝑖𝑛 𝑒𝑖𝑡ℎ𝑒𝑟 the construction...

01 January 1970 662 10 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

Determining the worth of a point improvement in Hamilton Depression Scale?

Dear readers, Thanks for your attention. I am wondering about the health economic problem of quantifying the value of interventions which a) prevent, b) improve symptom profile and c) ultimately...

05 August 2024 3,246 1 View

Conjugation of PEG-Amine to an Amino Acid Using EDC?

I am attempting to conjugate PEG to an amino acid at the C-terminus, for the purposes of producing nanoparticles. I have been told that PEG modified with amine groups can be used for this purpose,...

31 July 2024 2,033 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Is it possible to use a safer acid instead of monochloroacetic acid to convert bacterial cellulose to carboxymethyl cellulose?

Hi, researchers, Is it possible to use a safer acid instead of monochloroacetic acid to convert bacterial cellulose to carboxymethyl cellulose?

29 July 2024 4,570 0 View

What is the best method to detect the chemical composition of pollen ?

I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?

28 July 2024 5,331 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

My cfDNA extraction protocol using silica beads works with plasma collected in COD SAGM bags but not with plasma collected in K2 EDTA tubes. Why so?

I am currently performing cell-free DNA (cfDNA) extraction from plasma using an in-house developed kit that employs silica-coated magnetic beads. My protocol works effectively with plasma obtained...

28 July 2024 3,559 0 View