Maximum 0.5 hour rainfall from daily rainfall?

More Arun Lakkad's questions See All

SWAT-CUP format of Daily Observed data?

I want to calibrate the daily sediment data by using SWAT-CUP. I don't found the exact format of daily observed data to edit into SWAT-CUP and so that the calibration process is not...

01 February 2016 8,795 3 View

Does anyone know the procedure of MUSLE in GIS framework?

I know that GIS works cellwise means all the parameters of USLE i. e. K, LS, C and P are derived Cellwise (Gridwise) in GIS framework but in case of MUSLE, we have to estimate sediment yield at...

07 August 2015 3,482 5 View

What are the harmful effects of these extreme rainfall on the health of newborns? What are the reasons for that?

Extreme rainfall associated with climate change is causing harm to babies in some of the most forgotten places.

01 March 2021 5,647 4 View

Can polymer concentrations be calculated based on the number average molecular weight?

Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...

28 February 2021 7,882 2 View

How to resolve Gaussian error termination " Error termination via Lnk1e in F:\G16W\l103.exe" for TS(QST3)?

When I run the job for TS(QST3) in gaseous phase, it was completed without any error. But when I add water in CPCM model it terminated with an error: Inconsistency: ModMin= 2 Eigenvalue=...

21 February 2021 3,198 2 View

Using the Pfaffl method: Is it possible that the ratio of the calibrator does not equal 1?

Hi all, I have a question regarding calculations using the Pfaffl method. I have 3 groups per experiment: 1 control group (calibrator) and 2 treatment groups with 6 to 7 biological repeats per...

19 February 2021 8,351 2 View

How to calculate radial distribution function (RDF) of a complex from Ab initio MD simulation trajectory?

Hi all, Is there any software or webserver to read the molecular dynamics (MD) simulation trajectory which obtained from Ab initio MD simulation to calculate the atom-atom radial distribution...

25 January 2021 9,474 3 View

Solving diffusion- reversible chemical reaction equation: How to solve both terms numerically?

I am using finite difference method to discretize the parabolic equation (explicit method), but confused about the chemical reaction term. Solving the generic equation for i specie involves a...

24 January 2021 1,149 18 View

Doubt in DFT geometry preparation?

Hi all, I am trying to perform some ab inito DFT calculations using cp2k code. I have a unit cell of 120 atoms and would like to know how to refine or reduce the number of atoms in the unit cell...

20 January 2021 6,024 3 View

Why it is required to optimize a unit cell generated from cif lattice parameters and atomic coordinates during ab initio solid state calculations?

A cif file represents a unit cell with minimum energy. My question is, in the start of any ab initio calculation for unit cell generated from the cif file, why we are advised to optimize cell...

19 January 2021 9,883 3 View

Is it possible to calculate entalphy of LiBr/H2O or another solution if we know correlation of specific heat without using any software?

17 January 2021 5,522 3 View

What is the best way to calculate electrical conductivity of semiconductors and the same system with a layer of oxide using Quantum Espresso?

I have tried BoltzTrap, and EPW but I'm not sure whether Boltzmann Transport Equation is a right approach for a complex system (semi cond. + an Oxide layer or even the semiconductor itself). Also...

11 January 2021 4,597 4 View

Sheikh Hefzul Bari

You can use IMD (Indian Meteorological Department) reduction formula to calculate short duration rainfall from 24hrs rainfall. You can also use Bell's method.

Yassine Bouslihim

There is no good method to estimate without some hourly local data. Else one could assume taking 1/3 of max daily rainfall of a month (R srinivasan)

https://groups.google.com/forum/#!topic/swatuser/kpZMCke3BvU