Mango peel utilization?

tanveer ahmad Ahmad @Tanveer_ahmad_Ahmad

01 January 2015 0 4K Report

pls send me research article on mango peel and its utilization

Badges
Science topic

Similar topics
Composition Studies
Articles

More tanveer ahmad Ahmad's questions See All

Can one tell me how to degreded lignin ?

degradation of wooden material

02 March 2016 8,701 3 View

Is there any expert in Smart PLS who can help me?

Dear colleagues, I have a manuscript that needs an expert in smart PLS to run the analysis, Is there anyone expert and ready to help me, please?

01 March 2021 8,212 3 View

Can't recognize exact phase and PDF card no of Silicon carbide in XRD?

We have deposited silicon carbide on carbon substrate using one PVD technique. Due to amorphous behavior of SiC at low deposition temperature, we performed heat treatment of those films at...

22 February 2021 2,072 3 View

How can we reduce the SRMR (0.2 to 0.8) to make model fit?

Dear researchers I will be honored if you can help me to reduce in correcting SRMR in SEM_PLS. All the measures (AVE, CR, VIF, CA, HTMT) are good except SRMR = 0.15

09 February 2021 9,552 3 View

Which Journals would you advise to submit a Letter which briefly talks about neurosurgical treatment of neuro-oncological patient during Sars-COV-2?

Possibily not an open access journal which does not add any publishing costs once being accepted. Thank you in advance

09 February 2021 717 6 View

How to address SRMR (0.2 to 0.8) to make model fit?

Dear researchers, I want to update my knowledge regarding data analysis. I will be honored if you can help me to reduce in correcting SRMR in SEM_PLS. All the measures (AVE, CR, VIF, CA, HTMT) are...

09 February 2021 1,702 1 View

How to do mono formylation of N,N-diethyl-3-methoxybenzamide?

I have attempted the formylation of the above mentioned compound using a very well reported protocol using secondary Butyl Lithium and TMEDA at - 78 degrees Celsius. I have done it quite a few...

08 February 2021 2,793 2 View

Can some one help me to find shear stress and normal across middle of the interface along lap length??

i modeled single lap joint using COMSOL Multiphysics software. i wanted to find shear and peel(normal) distribution across middle of the overlap length pls check the image attached

19 January 2021 6,845 3 View

What is suitable etching resist coating for polished Titanium Grade 5 surface?

Currently we start a chemical etching project. This project involved etching a polished titanium grade 5 surface part. We facing a problem where by our etch resist coating peel off during etching...

15 January 2021 1,592 3 View

Which antimicrobial test will be suitable to determine antimicrobial activity of silver nanoparticles?

There are some journal articles that reported well diffusion method to determine the antimicrobial activity of silver nanoparticles. Meanwhile, some reported disc diffusion method. Which method is...

06 January 2021 7,123 4 View

Is it possible for peeling off pedot:pss film on bare glass?

I try to fabricate free stranding pedot:pss film. I already prepare pedot:pss film by using OTS treated glass. But in many papers, they just using bare glass not OTS treated glass. I did it, but I...

05 January 2021 6,968 1 View