I am looking for a battery model: a) Variable Charging and discharging efficiency, i.e. change with SoC level b) Self-discharging is variable, i.e. change with internal temperature of battery or SoC level
Thank you very much. I will have a look.
Maybe some of my work might be helpful to you:
Conference Paper Battery Capacity and Discharge Current Relationship for Lead...
Thesis Discrete linear constrained multivariate optimization for po...
Thank you for sharing your research.
Working on chandrayaan-2 DFSAR data, there are three datasets available: 1) Slant range image data product: The slant range complex image file. Each pixel is represented by two 4-byte floating...
02 March 2021 8,481 3 View
Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...
28 February 2021 7,016 1 View
I have a doubt on how to select the inductor and capacitor value when I want to implement MPPT controller. This is because we always take a maximum output voltage and current but in this case, we...
28 February 2021 3,637 2 View
For example in one research article the Elemental analysis values of COF-TpPa-1 ( Triformylphloroglucinol (Tp) (63 mg, 0.3 mmol), Paraphenylenediamine (Pa-1) (48 mg, 0.45 mmol) are as follows...
24 February 2021 1,265 6 View
24 February 2021 4,833 3 View
Hello everyone, I have some PHAs blended with fillers and nucleating agents, yet I don't know what kind of fillers or nucleating agents. The producer has shut down and there's no way to get in...
24 February 2021 1,356 8 View
Suggest me the method or some other software to calculate the above said data for nanoparticles.
21 February 2021 3,350 7 View
Hi, any one please guide me; SSR primers are species specific or trait specific. i have few primer which was reported in articles for wheat yield can i use these similar primer for lentil yield...
20 February 2021 315 4 View
In CDA analysis we have three stages, viz., description , interpretation, and reproduction. Why have all CDA studies neglected the third stage?
18 February 2021 6,483 3 View
How to find the air side pressure drop in a spiral fin cross flow heat exchanger? The pressure difference at the inlet and outlet is very low compared to the experimental results, which I...
18 February 2021 1,109 2 View
I am designing a small grid connected solar PV power-plant. As the battery's capacity is specified in Ah and demand in kWh. What is the best way to size the battery bank? I have battery price in...
28 February 2021 1,638 3 View
Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...
28 February 2021 2,116 1 View
Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...
25 February 2021 8,749 6 View
Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...
24 February 2021 3,785 3 View
I am reading papers on batteries and although mostly people have reported ionic conductivity in Scm-1 but some have reported DC conductivity as well I and am confused as to what that is. Any help...
21 February 2021 9,207 6 View
Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...
21 February 2021 8,659 1 View
I am working on cathode material. I have made different Li-ion coin cell against Li metal using commercial available cathode materials such as LCO,LMO, LFP and NMC and also with the lab...
18 February 2021 1,450 3 View
I want to know the effect of thermal conductivity characteristics of solid electrolytes on the all-solid battery, but I don't know which paper to refer to. Is there a paper on thermal behavior?
15 February 2021 8,806 2 View
I am designing a DAB DC DC Converter and when I am connecting a battery block in Matlab and fix its specification lets say 350 V and 25 A, when I am giving input as 600V, Battery would charge to...
11 February 2021 3,110 1 View
I have seen it in multiple research articles that authors use certain approaches to predict electric vehicle battery's state of charge(SoC) and then they compare it with battery's true SoC. So I...
11 February 2021 9,070 3 View