Is there free tool to simulate vaccine-immune system response other than C-Immsim and VaccImm?

Abdelrahman H. Abdelmoneim @Abdelrahman-Abdelmoneim

21 April 2020 1 4K Report

The two mentioned tools are not working probably.

Ammar Danazumi

Hello, did you find an answer to your question? I am also looking for an alternative tools to simulate immune response.

Badges
Science topic

More Abdelrahman H. Abdelmoneim's questions See All

How to plot the probability paper of Gumbel distribution using R programing?

In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...

25 February 2021 5,229 3 View

Greetings Doctors, If i did a same experiment for a 2 populations and i need to publish this work in a 2 different papers?

If i did a same experiment for a 2 populations and i need to publish this work in a 2 different papers can i use the same word in the writing of these 2 papers or this would considered as...

04 February 2021 4,648 4 View

How to simulate Sloshing water using Dynamic mesh in ANSYS Fluent ?

I am trying to model sloshing water in a tank in ANSYS Fluent using Wall motion. BUT it seems that System coupling is not responding to wall motion and it works only with Dynamic mesh.

20 January 2021 2,963 3 View

How can i properly obturate more than one canal at the same time in one tooth using CLC without interfering with the canal positionand accessory file?

#Rootcanal #Obturation #Endodontics

29 December 2020 5,982 2 View

Is it possible to deliver hydrophilic drugs to lymphatic system after oral administration? what kind of drug delivery system could be used if (yes)?

Is it possible to deliver hydrophilic drugs to the lymphatic system after oral administration? what kind of drug delivery system could be used if (yes)?

01 July 2020 1,793 1 View

How to estimate the compressor's weight/mass with a given pressure ratio and mass flow rate ?

I want to estimate the mass (does not have to be accurate) of a centrifugal compressor knowing the required mass flow rate and pressure ratio. Thanks in advance!

07 May 2020 2,487 1 View

How to design load curve to take measurements for solar heater through the day?

I make measurements for the master thesis of solar heater. I need to design a load curve to obtain measurements for natural consumption of people. I will discharge solar heater tank through the...

29 February 2020 1,413 4 View

Is there any good references for autocorrelation testing of time-series data?

I'm looking for any recommendations on solved problems/resources on Autocorrelation statistical testing of time-series data such as : 1. Lagrange Multiplier (LM) testing. 2. Durbin-Watson...

28 November 2019 5,026 3 View

Can sodium content of a drug affect ECIS impedance readings?

In experiments to detect effects of GPCR agonists on barrier function of endothelial cells, different agonists can have different sodium contents. In my case, I use the agonists at different...

18 November 2019 3,261 1 View

Equation in book of Soil Mechanics in Engineering Practice" by Terzaghi & Peck (1958) ?

hello do you any one have this reference Soil Mechanics in Engineering Practice" by Terzaghi & Peck (1958) i need some information from it thank you

09 November 2019 2,845 3 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Can we distinguish the type of free fluid inside the pelvic and abdominal cavities whether blood or serous fluid using the ultrasound?

during ultrasound examination of acute abdomen, sometimes we see free fluid , can we know the type of fluid ,whether blood or not , using ultrasound only? if yes , what are the sonographic...

01 March 2021 7,476 4 View

Can anyone help me with the administration of the "Mind the Gap" Scale for satisfaction with transition to adult care?

We are working on a study focused on adolescents' transition to adult care and are looking for a validated measure for satisfaction with the transition. So far the only measure that we have came...

28 February 2021 2,338 1 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

How to calculate Ligand-active site distance in a ligand-protein complex from MD simulation?

I have run a MD simulation of a ligand-protein complex in GROMACS using CHARMM forcefield. Reviewer has asked me to calculate Ligand-activesite distance and binding free energy of ligand with...

27 February 2021 4,703 1 View

Is there an open source free software for text mining and sentiment analysis?

I am looking for a free software for text mining and sentiment analysis for my research on customer review mining (it involves calculating polarity of attributes,opinion oriented information...

25 February 2021 1,920 6 View

Which are the journals for free paper publication?

A bunch of flower for everybody. I would like to ask about the list of journals which we can publish our paper for free. Thanks in advance. Sincerely Walid

25 February 2021 9,790 3 View

Suggestions for occupational stress surveys?

I am currently writing a masters thesis on reasons for occupational stress in the early childhood classroom, and want to include a short survey assessing participants work-related stress levels. I...

24 February 2021 8,678 2 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View