Is there any study to experimentally show particle trajectory of three different minerals on a single bubble under same hydrodynamics conditions?

More Ahmad Hassanzadeh's questions See All

Is IMPACT FACTOR justified in case of Taxonomy?

There is huge pressure of getting good impact factor on scholars now a days. On the other hand Taxonomy is a very dry subject and the concerned papers can only get citation in same group of organism.

26 February 2021 5,851 1 View

Why tick's salivary gland extract didn't run in the gel (SDS PAGE )??

Greetings, I want to make SDS PAGE for my sample (Tick salivery gland extract), I tried concentrations 10%, 12%. I also tried high molecular weight ladder. But the protein stopped at the top and...

25 February 2021 7,698 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

How to measure the pH of Peat Soil?

Peat possess organic content above 75% and is highly acidic in nature (i.e. pH < 4). Before commencing stabilization, it is mandatory to know about the pH level of peat. Therefore, your...

18 February 2021 9,424 7 View

How to Measure Consumer Willingness To Change from petroleum-fueled vehicle to electric vehicle?

I wanted to calculate the probability of one consumer shifting from using a petroleum-fueled vehicle to an electric vehicle. Since my background is in engineering I do not know much about how to...

15 February 2021 9,190 5 View

Having trouble mounting the sections on the slides for IHC staining, what solution should I use?

Hello everyone, I just started learning IHC staining and I have some frozen sections to practice with in a 96-well plate. I'm having trouble mounting the sections on the slide, a colleague told me...

08 February 2021 6,880 3 View

How to use Image Lab to take an image for the bands and the ladder in the same image merged together in Western Blot?

Hello everyone. I was trying to use Image Lab software to take an image of both the ladder and the samples merged together in one image to see the position of the bands according to the ladder MW,...

04 February 2021 9,996 2 View

Need a research paper for multi speaker and single microphone acoustic echo cancellation?

Hi, I am working on a problem that involves multiple smartphones/tablets. All devices are playing the same sound with synchronization difference up to +- 5ms. Now, there is an echo issue and I...

02 February 2021 5,929 3 View

Can I use the result from a pilot study to decide the minimum sample size ?

Can I use the result from a pilot study to decide the minimum sample size required to compare the means using independent sample t-test ? Or any other way that can help me to determine the...

29 January 2021 7,677 6 View

How to prepare secondary antibody from lyophilized antibody?

So I'm new to lab research and learning Western Blots these days. I ordered my secondary antibody and it arrived in a powdered form. Here is the...

27 January 2021 5,402 3 View

What could be the reason for XRD pattern starting from very high counts/intensity at 3 degree 2 theta?

I am working on XRD analysis of the clay minerals from the sea sediments. My XRD pattern shows very high counts at the start of the XRD pattern (3 degree 2 theta) which is very unusual. The counts...

31 January 2021 4,493 9 View

Is it possible to prepare clay minerals by mixing pure oxides of required elements? What would be theoretical difficulties with it?

Practically this is not at all necessary. But theoretically, would hydrous/hydrothermal synthesis be enough (like mix 1 mole alumina gel and 4 mole silica gel and gently heat) or would it require...

26 January 2021 6,403 3 View

How can I realise the separation of clay mineral part from soil ? and what is this process called ?

Hey; I am looking to work on clays in my soil samples, So I need to extract them first. I know that I should first remove all the bending agents that make the clay sheets stay connected like (...

24 December 2020 7,082 2 View

Which software should be used for XRD analysis in case of soils?

I am using XRD test for indentification of minerals and amount of it.

10 December 2020 8,173 4 View

How to identify and quantify glauconite and illite/other mica present in same sample from XRD analysis?

In glauconite bearing sand stone sample other mica group minerals(illite, muscovite etc.) are also present. I want to quantify the amount of glauconite and othermica group minerals. How, I can...

10 December 2020 5,793 19 View

How to obtain a mineral map using Hyperion image in ENVI or in Erdas Imagine?

Input is a Hyperion hyperspectral image. I followed steps Preprocessing, MNF, ppi, nD visualizer and SAM. Also spectral anayst used. I found minerals by spectral resampling of imagery spectral...

23 November 2020 8,915 4 View

Can SEM-EDS give a chemical formula?

I have attached an excel file with the quantification of a mineral I conducted EDS on. I have more excel files of minerals too as I know EDS spectra for only 1 sample will certainly not be...

03 November 2020 6,899 9 View

How can I obtain the cohesive energy density and solubility parameter for a crystal using the Materials Studio software?

Hello, I am currently analyzing properties of some minerals such as Bi2O3 by MD using Materials Studio, I need to obtain the cohesive energy density (CED) to obtain the solubility parameter,...

02 November 2020 4,356 1 View

Is it possible to create the plasma in chamber?

Hello As a graduate student, I work on building a plasma-effect layering system. Recently, we have been able to easily produce plasma through high voltage of about 2 kV and current of 500 mA (AC)...

18 October 2020 3,427 3 View

What are the steps involved in executing a search and match within highscore Plus for XRD patterns?

This is my first time using XRD and the highscore plus software, so any help would be appreciated. I want to execute a search and match to determine which minerals are present within my samples....

15 October 2020 2,086 7 View

Osama Rahil Shaltami

Dear Sir

I think the following papers will benefit you in your search

https://publications.csiro.au/rpr/download?pid=csiro:EP115922&dsid=DS3

https://www.saimm.co.za/Journal/v099n01p027.pdf

Article A computational fluid dynamics (CFD) model for a bubble sepa...

Best Regards

Ahmad Hassanzadeh

Dear Osama,

I appreciate your kind reply and suggested manuscripts.

However, all works were specified in numerical or theoretical studies. For instance, variations in the induction period for particle–bubble attachment is not physically measuring the phenomena.

I am indeed looking for any experimental study focusing on direct measurement of particle-bubble interaction using different minerals with same particle sizes (but diverse densities) implemented in turbulent (or even in laminar) conditions.

Best regards,

Ahmad

Yuexian Yu

Dear Ahmad,

My former colleague whose publication is attached below has been studying the attachment behavior of coal particles with different densities and bubbles for several years by using an self-designed apparatus which can track the particle trajectory on computer display. Potentially his work might benefit you. Please see attached.

Regards,

Yuexian