Is there any possibility to define such a formula in FLAC3D via FISH functions?

More Navid Yeganeh's questions See All

Should the effective stresses be constant during the effective stress numerical analysis?

Assuming running the undrained effective stress analysis in FLAC3D via Config FLUID using the effective stiffness and strength parameters, are we expecting the constant effective stresses in the...

06 July 2019 8,943 3 View

How can one remove the water level from the FLAC3D simulation at some point?

Is it possible to deactivate the effect of water so that FLAC adds the amount of steady state PWP to the effective stresses in all zones such that all the stresses in the soil constitutive model...

05 June 2019 5,263 2 View

How are the horizontal stresses calculated in FLAC3D?

The very initial step of each project is setting up the in-situ stresses. Right after the said step as well as amidst the dynamic analysis, could you cast light on how FLAC internally does the...

04 May 2019 2,205 1 View

How to assign the appropriate values to the interface element properties in FLAC3D?

Hey There. I am seeking a batch of references whereby the cohesion, friction angle, and dilatancy of the interface element, e.g., between a concrete foundation and the soil mass, could be...

02 March 2019 808 3 View

In what condition is the assumption of the constant effective major stress applicable?

I was wondering what were the rationales behind making such an assumption in the soil mechanics and geotechnical earthquake engineering? Is it allowed to be used only in the static condition or it...

01 February 2019 4,073 1 View

Could you please set forth why the most of the increases in the pore-water pressure in the undrained condition would occur during the unloading?

Please find enclosed the attachment.

11 December 2018 9,455 1 View

How to elaborate the diminishment of PWP in the vicinity of a foundation in a soil-structure interaction system amidst an earthquake?

PWP: Pore-Water Pressure

09 October 2018 2,393 0 View

Where can the journal abbreviations be found?

I am wholly grateful to you if the Civil Engineering journal abbreviations source could be announced herein. TA! Navid

05 June 2018 1,185 2 View

Would you please shed light on the rationale behind the statement below?

The yielding stress of concrete material is considered to be the same as the characteristic compressive strength (fc0) of concrete.

05 June 2018 8,489 0 View

What is the appropriate distance between the side boundaries in a 3D numerical model of a soil-structure interaction system for a seismic analysis?

For instance, Rayhani and El Naggar (2008) posited that the said distance ought to be greater than five times of the superstructure width. Rayhani, M. H., & El Naggar, M. H. (2008). Numerical...

05 June 2018 536 4 View

Binary Logistic Generalized Linear Mixed model in SPSS. Is it doable?

I want to analyses the proportion of swimming sperm of three species of fish in two salinities. To analyse the proportion of swimming sperm in a Generalized Linear Model, I would use a Binary...

03 March 2021 2,297 3 View

Good morning research fellows, Has anyone worked with senna alata plant extract on any kind of fish?

Literatures on the piscicidal effect of sennaa alata is scanty. if you have any related litrature either in the bark, leaves or roots used as treatment to any aquatic organism please kindly help...

28 February 2021 9,138 2 View

Experimental Design: How deal with pseudreplicates with immunological and clinical-chemical paramaeters?

Hello everybody, I am investigating the influence of a toxinon various clinical-chemical and haematological parameters in fish. I have three treatments (control, low dose, high dose) in my...

24 February 2021 1,243 1 View

Hi i want to ask that in order to find out LC 50 (96 hours) of particular toxin for fish. Should we keep the animals with food or without food?

if we expose the fish after acclimatization to particular toxin in order to find out LC 50 (96 hours).Should we keep the fish off feed or with feed for that duration. Some literature show that...

24 February 2021 357 2 View

Measuring Total immunoglobulin whole-body of fish larvae?

Hi Dear All, I prepared the extract of fish larvae whole body with PBS. Then protein concentration of the whole-body extraction samples determined by the Folin-Ceiocalteu-Phenol method (Lowry...

17 February 2021 1,971 3 View

What is the identity of additional bands found during fish gut microbiome 16S V4 PCR amplification?

Hi, I am carrying out test PCRs for 16S amplicon sequencing on Illumina MiSeq. I am using standard V4 primers: 515F/806R. The aim is to profile the microbiome of fish guts under different...

16 February 2021 5,668 6 View

Is this the fragment of a sauropod tooth?

Dear colleagues. Fragments of this species are very rare from a terrestrial Lower Cretaceous locality from Germany. Up to now from this locality sauropods could not be proved with certainty. Other...

14 February 2021 2,310 1 View

Problem to dissolve 50%wt Glycerol in 4%wt PVOH 28-99 ??

Hello everyone, I am trying to prepare a solution out of PVA(Polyvinyl alcohol)_Glycerol_Wasser . (4% PVA 28-99 and 50% Glycerin) To prepare this solution I first add PVA to 80degree water and...

06 February 2021 2,300 3 View

How to remove inter-year variation from my assessment of seasonal variation?

I have a 30 year dataset of fish sampling. I know from previous analyses that there is a huge amount of variation between years in catch rates. What I would like to do is create a plot that shows...

01 February 2021 3,980 5 View

Can anyone help to find any research articles related to the below mentioned objective?

Astaxanthin used in surimi based products as colour enhancer or as an antioxidant! Regards & Thanks Asik Ikbal

25 January 2021 9,399 4 View