Hi everyone, I am interested in studying mentorship modelling in medical and health professionals education. I will appreciate if you could offer any guidence in regard to the new style of network-based mentoring & its use in medical education.
Abdulhafeez:
I have not done any research in this area so I am including what's available in RG regarding e-mentoring in medical education:
Best regards,
Debra
https://www.researchgate.net/publicliterature.PublicLiterature.search.html?type=keyword&search-keyword=+network-based+mentoring+and+its+use+in+medical+education&search-abstract=&search=Search
https://www.researchgate.net/publicliterature.PublicLiterature.search.html?type=keyword&search-keyword=e-mentoring+in+medical+education&search-abstract=&search=Search
Thank you Debra, that was helpful.
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
May members post flyers about opportunities to present at a conferehttps://veraeducation.com/nce? If so, where to post for the Virginia Educational Research Association? https://veraeducation.com/
08 August 2024 4,585 1 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...
06 August 2024 9,986 2 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...
05 August 2024 3,665 0 View
I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...
03 August 2024 6,028 4 View