Is the area of a trapecium a numerical method or an ortoganization of evodio-armenta-hoyos rivera

Jose Luis Armenta @Jose-Armenta-9

01 January 1970 1 2K Report

accord to perimeter of an atrapecium

is a+b+c+d

area

b times B times heihght /2

and is the same simettries than a numerical methods

and is also a ortogonolazitaion of gramh schmidt

Jose Luis Armenta

[email protected]

Badges
Science topic

More Jose Luis Armenta's questions See All

Is this a facetotecta nauplius?

This larva was captured using a plankton net in the Persian Gulf during the summer. I believe it may be a Facetotecta nauplius.

08 August 2024 3,744 4 View

Why do open and free science in a world where science is not open and free?

Because I have realized that the world tends more and more to do open and free science and there is a trend more and more to choose free databases, free tools and open access platforms.

01 August 2024 10,045 1 View

Following click reaction in cell lysates, protein is immobile and remains at the top of the gel in SDS-PAGE?

I am using CuBr/THPTA for a click reaction in total cell lysates. I am facing issues with my protein sample in non-reducing SDS-PAGE where it's not migrating properly and most of it remains at the...

29 July 2024 949 4 View

Which filtration method to go for run off water from dirty solar panels to be used again?

We are working on a robot that cleans solar panels using fresh water supply and a rotating brush. We are trying to conserve as much water at possible by recycling the dirty water that is collected...

28 July 2024 5,776 2 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,747 0 View

Comparison of Methanol and ethanol treatment on collagen based scaffolds?

Kindly share a research paper that explains the effect of Methanol and ethanol treatment on collagen based scaffolds. How it increases porosity and swelling. Kindly help me find a paper. Thank you

24 July 2024 3,937 0 View

When making abraxane with Nab tech, why is 9:1 Chloroform&EtOH used as solvents?

Is it the best optimization ratio based on experiments?

22 July 2024 8,169 0 View

Can diamond be grown using molecular beam epitaxy?

22 July 2024 9,753 2 View

How to represent Annexin V apoptosis study data in publications?

Hi, I have performed an Annexin V apoptosis study using flow cytometry and got quite good results. I doubt how to represent the quadrant percentages in the final bar graphs. Some papers only show...

13 July 2024 356 3 View

How can I use LabVIEW to control of an ethernet-based driver?

Hello everyone, I am new to LabVIEW, right now we need to control the movement of an ethernet-based stage drive. We got the sample code from a collaborator but their instrument is USB-based, so we...

11 July 2024 5,385 2 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 717 0 View

If we are using snowball sampling technique, how do we justify the true representativeness of the sample statistically? is there any statistical test?

Are there any statistical methods to justify your sampling technique using SPSS or AMOS?

05 August 2024 9,153 4 View

What are the shear and normal stiffness values of an LLDPE liner in 3D numerical modeling of a stockpile?

I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...

05 August 2024 3,664 0 View

What are possible strategies can be used to analyze data under sequential explanatory mixed method approach?

Better ways to analyze the qualitative and quantitative data in a sequential explanatory mixed method approaches

04 August 2024 2,702 6 View

Why 3 replicates for most biological assays? Is it enough to examine the data fits normal distribution?

Just bounced on me. Before statistically analysing significant difference, shouldn't we see if data fits normal distribution first? Is 3 replicates enough to testify the hypothesis of normal...

31 July 2024 8,141 13 View

Request for Advice: Starch Metabolism Research Project?

I am currently considering a research project focusing on a comparative analysis of starch metabolism in orchids and roses. I am particularly interested in identifying the types and quantities of...

30 July 2024 4,265 2 View

Can the limit of quantification (LOQ) of an analytical method fall outside its linear dynamic range, or must it always be within it?

Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...

29 July 2024 7,197 9 View

Pragmatic inquiry research design?

Employing a pragmatic inquiry research design, looking for published research using this method, employing qualitative research data collection methods of semi-structured interview and focus...

28 July 2024 539 2 View

Can i apply a public questionnaire but analyse it with a different data analysis method?

First, thanks for taking the time to read my puzzle 🥹! I am currently working on the methodology part of my dissertation, and I have chosen a questionnaire as the instrument for my quantitative...

27 July 2024 3,457 3 View

How to determine method detection limit in an analytical method?

I know the difference between instrumental LOD and method LOD but my query is - in case of any sample whose concentration is zero or not detected by the instrumental LOD, is it possible to get...

24 July 2024 6,591 5 View