If not, he hats the best way to make it so?
No, it is NOT electro active.
Regards, Leonid
Bare PDMS is not electroactive, but could become a dielectric elastomer actuator if it is sandwiched between two electrodes. See this paper http://www.seas.harvard.edu/suo/papers/292.pdf.
I believe that obtaining 'authentic' results is pretty hard, so this brings me here to check if I am doing things right. I would like to detect a protein using Alexa 568 Ab in my cells. I tuned...
09 October 2018 9,110 4 View
Some journals ask for a plain text manuscript where there is a need to convert all the references to plain texts. I know this can be done using EndNote, but is there a similar process defined for...
07 August 2018 6,749 6 View
05 June 2016 5,711 3 View
I need to deposit Fe3O4 thin film over PDMS and I think sputtering is the best option available. However, I do not have an iron oxide target. That is why I was thinking of making a Fe3O4 target...
04 May 2016 6,264 5 View
01 February 2016 6,190 2 View
31 December 2015 7,217 2 View
11 December 2015 828 4 View
10 November 2015 3,177 7 View
10 November 2015 8,155 6 View
I need to measure the stiffness of nano grass substrates with different densities. How can I simulate this and how can I instrumentally approve it? Indentation methods don't seems to be applicable...
09 October 2015 4,794 2 View
I am making polymer composite by solvent mixing method. When I am trying to add filler solution in polymer solution it quickly get solidified. How to make them then uinform? It doesn't give time...
03 March 2021 7,540 4 View
Anyone can recommend any books on such topics? Thanks in advance.
02 March 2021 8,457 2 View
Hello, I am working on the photocatalytic degradation of PEG 400. I would like to know if it's possible to determine the degree on polymerization based on NMR integration, or by the MW of the...
02 March 2021 6,186 3 View
I want to polymerize TEOS on a surface. I know that NH4OH is a preferred catalyst and an alcoholic solvent should be used .But I can not find certain amounts of each material to use. Does any one...
02 March 2021 1,404 6 View
Incompletely cross-linked pdms are difficult to remove.
01 March 2021 798 3 View
Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...
28 February 2021 7,882 2 View
What could be the reason of moisture at the sides of Vial when I am preparing my polmyer+DMSO solution for membrane fabrication? What etiquettes I am possibly missing here?
28 February 2021 6,516 5 View
I am working on a preparation of representative polymeric structures of some popular polymers, such as polyimide or PTFE for MD simulation, during which a single nitrogen or oxygen atom will be...
24 February 2021 8,105 3 View
Hello everyone, I have some PHAs blended with fillers and nucleating agents, yet I don't know what kind of fillers or nucleating agents. The producer has shut down and there's no way to get in...
24 February 2021 1,356 8 View
I want to remove PDMS oligomers from the surface of nanolayers. I have just read a very helpful paper about the compatibility of PDMS with different solvents( Solvent Compatibility of...
24 February 2021 7,845 5 View