Hi. My case study flood area has a Y-shape, with two rivers joining in one channel downstream. I have two hydrograms for each upstream river and I wonder if I can use both as upstream boundary conditions in Hec-ras and how.
Yes,
Add two upstreams connections and add both conditions separately. You don't need to add two conditions at a single point
Dear Muhammad thanks for your answer. Does it work also in 2D flood modelling?
Yes! it's possible.
Yes, you can give multiple upstream hydrographs in most of the models including HEC-RAS, Mike11, etc.
Actually, I am running cfd simulation for a heat exchanger which has two fluids one hot and other one is cold fluid. there is a solid domain between them, which I removed and instead I have used...
01 March 2021 9,537 2 View
I am simulating Heat Exchanger. I have tried and tested all the methods to resolve this issue from the internet like refining mesh, improving skewness and orthogonal quality ,extending outlet to...
01 March 2021 6,985 3 View
Increased heat, drought and insect outbreaks, all associated to climate change, have increased wildfires. Decreasing water supplies, declined agricultural yields, health impacts in cities owing to...
01 March 2021 7,168 9 View
Hello, I have used the shell function on SpaceClaim to create thin solids for the model I am studying. These are contained within an enclosure for my study. I chose this approach as it avoids the...
24 February 2021 8,856 3 View
I am using Abaqus to simulate a plate with in-plane loading. The boundary conditions allow the right edge to move up and down, the displacements on the left edge are fixed. There is no rotation...
23 February 2021 711 3 View
I want to map these river geoforms with as little subjectivity as possible. I have a high resolution DEM generated by drone data.
22 February 2021 7,800 3 View
Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...
22 February 2021 4,882 3 View
Hello, I created a very tall tower (>1000m) and applied pressure boundary conditions at the inlet (bottom) and outlet (top) that correspond to the pressure are their relative altitudes....
22 February 2021 9,972 4 View
I am trying to simulate a simplified version of a beam resting on 10 points using Abaqus. The solutions I want to obtain are the Reaction Forces in each resting point or area when applying a...
21 February 2021 3,075 2 View
Hello I am trying to simulate crawling motion of a bilayer beam using Abaqus. Kind of similar to this: https://youtu.be/os-Z3ucoFpA I am using multiphysics enabled (diffusion, deformation,...
20 February 2021 2,916 1 View