Interpretation of different indices in AMOS (SEM)?

More Raja Ahmed Jamil's questions See All

Matching responses from same respondent in a longitudinal study?

As there is always some attrition in longitudinal research, then how can a researcher match the responses from same respondent at T1, T2 and T3...... in a longitudinal survey design? So that a...

08 September 2017 4,754 4 View

Paper getting reviewed before sent to any journal?

What are the possible alternative ways to get paper reviewed and refined before actually sending it a journal for review? I have drafted a manuscript but I am not sure where does my work actually...

07 August 2015 5,628 6 View

Questionnaires needed on anticipated regret?

I need questionnaire for two variables 1. Anticipated regret for family 2. Anticipated regret for work

03 April 2015 2,018 0 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

If we are using snowball sampling technique, how do we justify the true representativeness of the sample statistically? is there any statistical test?

Are there any statistical methods to justify your sampling technique using SPSS or AMOS?

05 August 2024 9,153 4 View

How can I interpret the data without the need of solving it manually?

How can I interpret the data gathered without solving?

03 August 2024 9,054 3 View

Is it necessary to covary exogenous constructs in a structural model?

I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...

03 August 2024 6,028 4 View

I need the datasets of Microgrid for system identification?

Hi I am working on data driven model of the microgrid, for that, i need the reliable datasets for the identification of MG data driven Model. Thanks

02 August 2024 5,748 4 View

Should I remove an item from a scale to raise Cronbach's alpha and McDonald's omega or is it better to leave it if they are both over .7 already?

Hello! I have this scale which had 10 items initially. I had to remove items 8 and 10 because they correlated negatively with the scale, and then I removed item 9 because Cronbach's alpha and...

01 August 2024 4,606 7 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,233 4 View

I need a reliable source or an example supported by excel sheet to understand Fuzzy Vikor?

27 July 2024 5,916 1 View

Why only alpha wave of brain are found in some patients?

I have found an EEG where only alpha waves are present. Beta waves are not found in active patients. What interpretations ?

26 July 2024 4,741 1 View

Can you recommend provider Intermediate laboratory test for hydrocarbon, polyethylene & polypropylene?

Accredited laboratory of JV "Uz-Kor Gas Chemical" LLC (Uzbekistan) is looking for providers to conduct interlaboratory comparison tests on gas chromatographic analysis of hydrocarbons (component...

25 July 2024 8,108 0 View

Muayyad Ahmad

mostly, all the indices are recommended to be above .90, except the error one which is RMSEA to be less than .10 and some textbook less than .06

Regards

Asyraf Afthanorhan

There are three categories fitness from Amos output:

a) Parsiminous fit: Chisquare/df

b) Absolute fit: Chisquare, RMSEA, GFI

c) Incremental fit: AGFI, CFI, TLI, NFI.

Hair et al., (1995, 2010) and Holmes smith (2006) recommend the use of at least one fitness index from each category of model fit.