In Tight-binding model how should I sample the k-point grid taking into account the time reversal symmetry ?

Rita Maji @Rita-Maji

30 November 2016 1 7K Report

let's say for graphene unit cell or any type of supercell for 2D geometry

Gerardo G. Naumis

There are many ways. One is to use special points

taking into account symmetry. See,

Special points for Brillouin-zone integrations

Hendrik J. Monkhorst and James D. Pack

Phys. Rev. B 13, 5188 – Published 15 June 1976

Badges
Science topic

More Rita Maji's questions See All

Has anyone tried eBioscience Foxp3 / Transcription Factor Staining Buffer Set with TdTomato+ cells?

Hi all, I stained tdTomato+ cells (PBMCs and Jurkats) with eBioscience Foxp3 / Transcription Factor Staining Buffer Set for the foxp3 and I completely lost the signal of tdTomato. I tried to fix...

10 February 2021 5,863 2 View

How do I correct an inaccurate citation?

I was asked to verify a citation: Drugs and galencials, by D. C. Garratt, B.Sc., Ph.D (Lond.),... The author's first name is Emerson and the last name is Beeler. It was incorrectly cited as...

03 February 2021 5,272 3 View

Is there a way to get rid of TEA in a TLC plate in order to do proper staining?

Dear colleagues: I have been trying to establish a few HP-TLC methods in the lab. In general, for quantification purposes, I prefer CuSO4+acid charring, to primuline staining. Lately I have been...

20 January 2021 9,019 1 View

I have a challenge with a structure I optimized it's weight but the frequency constraint is not satisfied?

I know that frequency depends on material properties, geometry, support conditions and in plane loading. I have played around with these figures except that I maintained the same material steel...

26 December 2020 4,877 9 View

Is it possible to convert Fe2O3 to FeO for Electric Arc Furnace (EAF) steel slag?

I have done WD-XRFS analysis of slag samples, there Iron oxide gives as Fe2O3 but from literature and XPS analysis I have seen, majorly Iron stays in the slag as FeO in EAF, Hence I want to...

06 December 2020 7,973 2 View

How can I coat reduced graphene oxide on glass substrate?

I dispersed reduced graphene oxide in NMP solution and tried to coat it on a glass substrate using dip coating system. But I am not able to get a uniform coating. Please suggest me a solvent and a...

26 November 2020 8,929 4 View

How can I measure the sheet resistivity of my reduced graphene oxide thin film?

I tried to coat my NMP dispersed rGO sample on the glass substrate by dip coating system. Then I characterized it with four probe system for sheet resistivity measurement. But I got a very high...

16 October 2020 3,696 3 View

Heat and plastic in MTBE lipid extraction?

When extracting lipids with the MTBE method, the indicated temperature is RT. In addition, drying the samples in a speedvac is mandatory due to the presence of water and such procedure is long and...

14 October 2020 9,776 2 View

How do I make 3D device Schematic image ?

I want to make a device schematic with proper configuration. On the top of a quartz base I want to put MoS2 and Graphene and then contacts. I am giving a image for an example. Please suggest me...

04 May 2020 8,621 2 View

Does anybody have an idea of how to solubilize hydrophobic peptides?

My hydrophobic peptide (12 AA) is soluble in 100% DMSO. Given that I should encapsulate it in hyaluronic acid nanoparticles, I need that peptide is soluble or partly soluble in water. Does someone...

03 March 2020 8,025 4 View

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

I need to image mesoporous silica nanoparticles that are in ~100 nm size and do high resolution TEM to look at mesopores. what grids should I use?

Need to image mesoporous silica nanoparticles using the TEM. Also, need high resolution TEM images to see the mesoporous structure. Kindly suggest what kind of grids to use. Thanks, Shatadru

02 March 2021 1,787 2 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

How to address this issue in the analysis of Real-Time PCR results?

To dear Researchers, I was analyzing a series of concentration for estimation of Real-Time PCR efficiency. The concentration was 1:10. I used MS-excel to evaluate Slope. The result of slope was -8...

01 March 2021 8,683 4 View

RIA. How to measure?

When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...

28 February 2021 2,133 3 View

High aspect ratio hexahedral mesh optimization solver?

I am interested in evaluating mesh optimization solvers that converge to high aspect ratio unstructured hexahedral grids. In other words, I am interested in a solver that optimizes warpage,...

26 February 2021 7,279 2 View

How to make a time series imputation benchmark ?

Hello ! In a work, I have to benchmark different algorithms to fill in missing values in time series. I insist on the fact that this is imputation and not forecasting. In my case, I have access...

24 February 2021 7,470 7 View

How to interpolate from a time-series database ?

Hi, I am having trouble with a problem, in the field of Optimal Control and the generation of optimal time-series. Let's consider a system, whose dynamics are represented by dx/dt =...

24 February 2021 9,105 2 View

Can we recognize signs of the "volatility clustering" property of a time series in its time domain plot?

My purpose is to recognize the volatility clustering property without statistical tests such as The Lagrange Multiplier (LM) test.

24 February 2021 4,150 3 View

How can I obtain time series data by country on night-time light (brightness) ?

Hi everyone, Please, how can I obtain time series data by country on night-time light (brightness) ? I've tried, but so far all I can find are maps. I am looking for numerical data, especially in...

24 February 2021 8,625 4 View